Lines Matching +full:tuning +full:- +full:start +full:- +full:tap
7 by mmc.txt and the properties used by the sdhci-esdhc-imx driver.
10 - compatible : Should be "fsl,<chip>-esdhc", the supported chips include
11 "fsl,imx25-esdhc"
12 "fsl,imx35-esdhc"
13 "fsl,imx51-esdhc"
14 "fsl,imx53-esdhc"
15 "fsl,imx6q-usdhc"
16 "fsl,imx6sl-usdhc"
17 "fsl,imx6sx-usdhc"
18 "fsl,imx6ull-usdhc"
19 "fsl,imx7d-usdhc"
20 "fsl,imx7ulp-usdhc"
21 "fsl,imx8mq-usdhc"
22 "fsl,imx8mm-usdhc"
23 "fsl,imx8mn-usdhc"
24 "fsl,imx8mp-usdhc"
25 "fsl,imx8qm-usdhc"
26 "fsl,imx8qxp-usdhc"
29 - fsl,wp-controller : Indicate to use controller internal write protection
30 - fsl,delay-line : Specify the number of delay cells for override mode.
35 - voltage-ranges : Specify the voltage range in case there are software
39 - fsl,tuning-start-tap: Specify the start dealy cell point when send first CMD19
40 in tuning procedure.
41 - fsl,tuning-step: Specify the increasing delay cell steps in tuning procedure.
42 The uSDHC use one delay cell as default increasing step to do tuning process.
43 This property allows user to change the tuning step to more than one delay
45 tuning step can't find the proper delay window within limited tuning retries.
46 - fsl,strobe-dll-delay-target: Specify the strobe dll control slave delay target.
55 compatible = "fsl,imx51-esdhc";
58 fsl,wp-controller;
62 compatible = "fsl,imx51-esdhc";
65 cd-gpios = <&gpio1 6 0>; /* GPIO1_6 */
66 wp-gpios = <&gpio1 5 0>; /* GPIO1_5 */