Lines Matching +full:sub +full:- +full:controllers

5 - compatible: "brcm,bcm3368", "brcm,bcm3384", "brcm,bcm33843"
6               "brcm,bcm3384-viper", "brcm,bcm33843-viper"
12 The experimental -viper variants are for running Linux on the 3384's
16 ----------------
21 = Always-On control block (AON CTRL)
23 This hardware provides control registers for the "always-on" (even in low-power
27 - compatible     : should be one of
28 		   "brcm,bcm7425-aon-ctrl"
29 		   "brcm,bcm7429-aon-ctrl"
30 		   "brcm,bcm7435-aon-ctrl" and
31 		   "brcm,brcmstb-aon-ctrl"
32 - reg            : the register start and length for the AON CTRL block
37 	compatible = "brcm,bcm7425-aon-ctrl", "brcm,brcmstb-aon-ctrl";
41 = Memory controllers
43 A Broadcom STB SoC typically has a number of independent memory controllers,
46 describing these controllers as a parent "memory controllers" block, which
47 contains N sub-nodes (one for each controller in the system), each of which is
55 - compatible     : should contain "brcm,brcmstb-memc" and "simple-bus"
56 - ranges	 : should contain the child address in the parent address
58 		   the entire memory controller (including all sub nodes: DDR PHY,
60 - #address-cells : must be 1
61 - #size-cells	 : must be 1
65 	memory-controller@0 {
66 		compatible = "brcm,brcmstb-memc", "simple-bus";
68 		#address-cells = <1>;
69 		#size-cells = <1>;
71 		memc-arb@1000 {
75 		memc-ddr@2000 {
79 		ddr-phy@6000 {
91 - compatible     : should contain one of these
92 		   "brcm,brcmstb-ddr-phy-v64.5"
93 		   "brcm,brcmstb-ddr-phy"
95 - reg            : the DDR PHY register range and length
99 	ddr-phy@6000 {
100 		compatible = "brcm,brcmstb-ddr-phy-v64.5";
109 - compatible     : should contain one of these
110 		   "brcm,bcm7425-memc-ddr"
111 		   "brcm,bcm7429-memc-ddr"
112 		   "brcm,bcm7435-memc-ddr" and
113 		   "brcm,brcmstb-memc-ddr"
115 - reg            : the DDR sequencer register range and length
119 	memc-ddr@2000 {
120 		compatible = "brcm,bcm7425-memc-ddr", "brcm,brcmstb-memc-ddr";
132 - compatible	: should contain one of these
133 		  "brcm,brcmstb-memc-arb-v10.0.0.0"
134 		  "brcm,brcmstb-memc-arb"
136 - reg		: the DDR Arbiter register range and length
140 	memc-arb@1000 {
141 		compatible = "brcm,brcmstb-memc-arb-v10.0.0.0";
152 - compatible	: should contain one of:
153 		  "brcm,bcm7425-timers"
154 		  "brcm,bcm7429-timers"
155 		  "brcm,bcm7435-timers" and
156 		  "brcm,brcmstb-timers"
157 - reg		: the timers register range
158 - interrupts	: the interrupt line for this timer block
163 		compatible = "brcm,bcm7425-timers", "brcm,brcmstb-timers";