Lines Matching +full:buck +full:- +full:e
4 - compatible : Should be "ti,tps65086".
5 - reg : I2C slave address.
6 - interrupts : The interrupt line the device is connected to.
7 - interrupt-controller : Marks the device node as an interrupt controller.
8 - #interrupt-cells : The number of cells to describe an IRQ, should be 2.
11 masks from ../interrupt-controller/interrupts.txt.
12 - gpio-controller : Marks the device node as a GPIO Controller.
13 - #gpio-cells : Should be two. The first cell is the pin number and
16 - regulators: : List of child nodes that specify the regulator
18 after their hardware counterparts: buck[1-6],
19 ldoa[1-3], swa1, swb[1-2], and vtt. Each child
25 - ti,regulator-step-size-25mv : This is applicable for buck[1-6], set this
28 - ti,regulator-decay : This is applicable for buck[1-6], set this if
34 pmic: tps65086@5e {
37 interrupt-parent = <&gpio1>;
39 interrupt-controller;
40 #interrupt-cells = <2>;
41 gpio-controller;
42 #gpio-cells = <2>;
46 regulator-name = "vcc1";
47 regulator-min-microvolt = <1600000>;
48 regulator-max-microvolt = <1600000>;
49 regulator-boot-on;
50 ti,regulator-decay;
51 ti,regulator-step-size-25mv;