Lines Matching +full:down +full:- +full:gpios
4 -------------------
5 - compatible: Must be one of
9 - reg: I2C device address.
12 -------------------
13 - interrupts: The interrupt on the parent the controller is
15 - interrupt-controller: Marks the device node as an interrupt controller.
16 - #interrupt-cells: is <2> and their usage is compliant to the 2 cells
17 variant of <../interrupt-controller/interrupts.txt>
19 are defined at dt-bindings/mfd/max77620.h.
21 - system-power-controller: Indicates that this PMIC is controlling the
24 [1] Documentation/devicetree/bindings/power/power-controller.txt
30 --------------------------------------
33 independently or among a group of other regulators with an adjustable power-up
34 and power-down delays (sequencing). GPIO1, GPIO2, and GPIO3 can be programmed
49 regulators, GPIOs and clocks specifies the enable source to be a flexible
50 power sequencer, the power up and power down delays can be specified in
51 the regulators, GPIOs and clocks flexible power sequencer configuration
54 When FPS event cleared (set to LOW), regulators, GPIOs and 32KHz
57 Sleep state: In this state, regulators, GPIOs
63 The configuration parameters of FPS is provided through sub-node "fps"
67 The FPS configurations like FPS source, power up and power down slots for
68 regulators, GPIOs and 32kHz clocks are provided in their respective
69 configuration nodes which is explained in respective sub-system DT
77 -------------------
78 -maxim,fps-event-source: u32, FPS event source like external
82 dt-bindings/mfd/max77620.h
84 - MAX77620_FPS_EVENT_SRC_EN0
86 - MAX77620_FPS_EVENT_SRC_EN1
88 - MAX77620_FPS_EVENT_SRC_SW
91 -maxim,shutdown-fps-time-period-us: u32, FPS time period in microseconds
95 -maxim,suspend-fps-time-period-us: u32, FPS time period in microseconds
98 -maxim,device-state-on-disabled-event: u32, describe the PMIC state when FPS
100 should go to sleep state or low-power
102 - MAX77620_FPS_INACTIVE_STATE_SLEEP
104 - MAX77620_FPS_INACTIVE_STATE_LOW_POWER
116 -maxim,power-ok-control: configure map power ok bit
124 If any of the rails goes down(which are enabled for POK
129 regulator, power, please refer respective device-tree binding document
130 under their respective sub-system directories.
133 --------
134 #include <dt-bindings/mfd/max77620.h>
140 interrupt-parent = <&intc>;
143 interrupt-controller;
144 #interrupt-cells = <2>;
148 maxim,shutdown-fps-time-period-us = <1280>;
149 maxim,fps-event-source = <MAX77620_FPS_EVENT_SRC_EN1>;
153 maxim,shutdown-fps-time-period-us = <1280>;
154 maxim,fps-event-source = <MAX77620_FPS_EVENT_SRC_EN0>;
158 maxim,shutdown-fps-time-period-us = <1280>;
159 maxim,fps-event-source = <MAX77620_FPS_EVENT_SRC_SW>;