Lines Matching +full:vin4 +full:- +full:supply

4 axp152 (X-Powers)
5 axp202 (X-Powers)
6 axp209 (X-Powers)
7 axp221 (X-Powers)
8 axp223 (X-Powers)
9 axp803 (X-Powers)
10 axp806 (X-Powers)
11 axp809 (X-Powers)
12 axp813 (X-Powers)
20 - compatible: should be one of:
21 * "x-powers,axp152"
22 * "x-powers,axp202"
23 * "x-powers,axp209"
24 * "x-powers,axp221"
25 * "x-powers,axp223"
26 * "x-powers,axp803"
27 * "x-powers,axp806"
28 * "x-powers,axp805", "x-powers,axp806"
29 * "x-powers,axp305", "x-powers,axp805", "x-powers,axp806"
30 * "x-powers,axp809"
31 * "x-powers,axp813"
32 - reg: The I2C slave address or RSB hardware address for the AXP chip
33 - interrupt-controller: The PMIC has its own internal IRQs
34 - #interrupt-cells: Should be set to 1
38 - regulator-ramp-delay: sets the ramp up delay in uV/us
41 - regulator-soft-start: enable the output at the lowest possible voltage and
43 AXP20x/LDO3: software-based implementation
46 - interrupts: SoC NMI / GPIO interrupt connected to the PMIC's IRQ pin
47 - x-powers,dcdc-freq: defines the work frequency of DC-DC in KHz
48 AXP152/20X: range: 750-1875, Default: 1.5 MHz
49 AXP22X/8XX: range: 1800-4050, Default: 3 MHz
51 - x-powers,drive-vbus-en: boolean, set this when the N_VBUSEN pin is
58 - x-powers,self-working-mode and
59 x-powers,master-mode: Boolean (axp806 only). Set either of these when the
60 PMIC is wired for self-working mode or master mode.
64 - <input>-supply: a phandle to the regulator supply node. May be omitted if
68 - regulators: A node that houses a sub-node for each regulator. Regulators
75 - x-powers,dcdc-workmode: 1 for PWM mode, 0 for AUTO (PWM/PFM) mode
84 AXP202/AXP209 regulators, type, and corresponding input supply names:
86 Regulator Type Supply Name Notes
87 --------- ---- ----------- -----
88 DCDC2 : DC-DC buck : vin2-supply
89 DCDC3 : DC-DC buck : vin3-supply
90 LDO1 : LDO : acin-supply : always on
91 LDO2 : LDO : ldo24in-supply : shared supply
92 LDO3 : LDO : ldo3in-supply
93 LDO4 : LDO : ldo24in-supply : shared supply
94 LDO5 : LDO : ldo5in-supply
96 AXP221/AXP223 regulators, type, and corresponding input supply names:
98 Regulator Type Supply Name Notes
99 --------- ---- ----------- -----
100 DCDC1 : DC-DC buck : vin1-supply
101 DCDC2 : DC-DC buck : vin2-supply
102 DCDC3 : DC-DC buck : vin3-supply
103 DCDC4 : DC-DC buck : vin4-supply
104 DCDC5 : DC-DC buck : vin5-supply
107 ALDO1 : LDO : aldoin-supply : shared supply
108 ALDO2 : LDO : aldoin-supply : shared supply
109 ALDO3 : LDO : aldoin-supply : shared supply
110 DLDO1 : LDO : dldoin-supply : shared supply
111 DLDO2 : LDO : dldoin-supply : shared supply
112 DLDO3 : LDO : dldoin-supply : shared supply
113 DLDO4 : LDO : dldoin-supply : shared supply
114 ELDO1 : LDO : eldoin-supply : shared supply
115 ELDO2 : LDO : eldoin-supply : shared supply
116 ELDO3 : LDO : eldoin-supply : shared supply
117 LDO_IO0 : LDO : ips-supply : GPIO 0
118 LDO_IO1 : LDO : ips-supply : GPIO 1
119 RTC_LDO : LDO : ips-supply : always on
120 DRIVEVBUS : Enable output : drivevbus-supply : external regulator
122 AXP803 regulators, type, and corresponding input supply names:
124 Regulator Type Supply Name Notes
125 --------- ---- ----------- -----
126 DCDC1 : DC-DC buck : vin1-supply
127 DCDC2 : DC-DC buck : vin2-supply : poly-phase capable
128 DCDC3 : DC-DC buck : vin3-supply : poly-phase capable
129 DCDC4 : DC-DC buck : vin4-supply
130 DCDC5 : DC-DC buck : vin5-supply : poly-phase capable
131 DCDC6 : DC-DC buck : vin6-supply : poly-phase capable
133 ALDO1 : LDO : aldoin-supply : shared supply
134 ALDO2 : LDO : aldoin-supply : shared supply
135 ALDO3 : LDO : aldoin-supply : shared supply
136 DLDO1 : LDO : dldoin-supply : shared supply
137 DLDO2 : LDO : dldoin-supply : shared supply
138 DLDO3 : LDO : dldoin-supply : shared supply
139 DLDO4 : LDO : dldoin-supply : shared supply
140 ELDO1 : LDO : eldoin-supply : shared supply
141 ELDO2 : LDO : eldoin-supply : shared supply
142 ELDO3 : LDO : eldoin-supply : shared supply
143 FLDO1 : LDO : fldoin-supply : shared supply
144 FLDO2 : LDO : fldoin-supply : shared supply
145 LDO_IO0 : LDO : ips-supply : GPIO 0
146 LDO_IO1 : LDO : ips-supply : GPIO 1
147 RTC_LDO : LDO : ips-supply : always on
148 DRIVEVBUS : Enable output : drivevbus-supply : external regulator
150 AXP806 regulators, type, and corresponding input supply names:
152 Regulator Type Supply Name Notes
153 --------- ---- ----------- -----
154 DCDCA : DC-DC buck : vina-supply : poly-phase capable
155 DCDCB : DC-DC buck : vinb-supply : poly-phase capable
156 DCDCC : DC-DC buck : vinc-supply : poly-phase capable
157 DCDCD : DC-DC buck : vind-supply : poly-phase capable
158 DCDCE : DC-DC buck : vine-supply : poly-phase capable
159 ALDO1 : LDO : aldoin-supply : shared supply
160 ALDO2 : LDO : aldoin-supply : shared supply
161 ALDO3 : LDO : aldoin-supply : shared supply
162 BLDO1 : LDO : bldoin-supply : shared supply
163 BLDO2 : LDO : bldoin-supply : shared supply
164 BLDO3 : LDO : bldoin-supply : shared supply
165 BLDO4 : LDO : bldoin-supply : shared supply
166 CLDO1 : LDO : cldoin-supply : shared supply
167 CLDO2 : LDO : cldoin-supply : shared supply
168 CLDO3 : LDO : cldoin-supply : shared supply
169 SW : On/Off Switch : swin-supply
171 Additionally, the AXP806 DC-DC regulators support poly-phase arrangements
174 AXP809 regulators, type, and corresponding input supply names:
176 Regulator Type Supply Name Notes
177 --------- ---- ----------- -----
178 DCDC1 : DC-DC buck : vin1-supply
179 DCDC2 : DC-DC buck : vin2-supply
180 DCDC3 : DC-DC buck : vin3-supply
181 DCDC4 : DC-DC buck : vin4-supply
182 DCDC5 : DC-DC buck : vin5-supply
185 ALDO1 : LDO : aldoin-supply : shared supply
186 ALDO2 : LDO : aldoin-supply : shared supply
187 ALDO3 : LDO : aldoin-supply : shared supply
188 DLDO1 : LDO : dldoin-supply : shared supply
189 DLDO2 : LDO : dldoin-supply : shared supply
190 ELDO1 : LDO : eldoin-supply : shared supply
191 ELDO2 : LDO : eldoin-supply : shared supply
192 ELDO3 : LDO : eldoin-supply : shared supply
193 LDO_IO0 : LDO : ips-supply : GPIO 0
194 LDO_IO1 : LDO : ips-supply : GPIO 1
195 RTC_LDO : LDO : ips-supply : always on
196 SW : On/Off Switch : swin-supply
198 AXP813 regulators, type, and corresponding input supply names:
200 Regulator Type Supply Name Notes
201 --------- ---- ----------- -----
202 DCDC1 : DC-DC buck : vin1-supply
203 DCDC2 : DC-DC buck : vin2-supply : poly-phase capable
204 DCDC3 : DC-DC buck : vin3-supply : poly-phase capable
205 DCDC4 : DC-DC buck : vin4-supply
206 DCDC5 : DC-DC buck : vin5-supply : poly-phase capable
207 DCDC6 : DC-DC buck : vin6-supply : poly-phase capable
208 DCDC7 : DC-DC buck : vin7-supply
209 ALDO1 : LDO : aldoin-supply : shared supply
210 ALDO2 : LDO : aldoin-supply : shared supply
211 ALDO3 : LDO : aldoin-supply : shared supply
212 DLDO1 : LDO : dldoin-supply : shared supply
213 DLDO2 : LDO : dldoin-supply : shared supply
214 DLDO3 : LDO : dldoin-supply : shared supply
215 DLDO4 : LDO : dldoin-supply : shared supply
216 ELDO1 : LDO : eldoin-supply : shared supply
217 ELDO2 : LDO : eldoin-supply : shared supply
218 ELDO3 : LDO : eldoin-supply : shared supply
219 FLDO1 : LDO : fldoin-supply : shared supply
220 FLDO2 : LDO : fldoin-supply : shared supply
221 FLDO3 : LDO : fldoin-supply : shared supply
222 LDO_IO0 : LDO : ips-supply : GPIO 0
223 LDO_IO1 : LDO : ips-supply : GPIO 1
224 RTC_LDO : LDO : ips-supply : always on
225 SW : On/Off Switch : swin-supply
226 DRIVEVBUS : Enable output : drivevbus-supply : external regulator
231 compatible = "x-powers,axp209";
233 interrupt-parent = <&nmi_intc>;
235 interrupt-controller;
236 #interrupt-cells = <1>;
239 x-powers,dcdc-freq = <1500>;
242 regulator-always-on;
243 regulator-min-microvolt = <1000000>;
244 regulator-max-microvolt = <1450000>;
245 regulator-name = "vdd-cpu";
249 regulator-always-on;
250 regulator-min-microvolt = <1000000>;
251 regulator-max-microvolt = <1400000>;
252 regulator-name = "vdd-int-dll";
256 regulator-always-on;
257 regulator-min-microvolt = <1200000>;
258 regulator-max-microvolt = <1400000>;
259 regulator-name = "vdd-rtc";
263 regulator-always-on;
264 regulator-min-microvolt = <2700000>;
265 regulator-max-microvolt = <3300000>;
266 regulator-name = "avcc";