Lines Matching +full:i2c +full:- +full:hdmi
1 * Analog Devices ADV7604/11/12 video decoder with HDMI receiver
4 HDMI receiver. The ADV7604 has four multiplexed HDMI inputs and one analog
5 input, and the ADV7611 has one HDMI input and no analog input. The 7612 is
6 similar to the 7611 but has 2 HDMI inputs.
12 - compatible: Must contain one of the following
13 - "adi,adv7611" for the ADV7611
14 - "adi,adv7612" for the ADV7612
16 - reg: I2C slave addresses
17 The ADV76xx has up to thirteen 256-byte maps that can be accessed via the
18 main I2C ports. Each map has it own I2C address and acts as a standard
19 slave device on the I2C bus. The main address is mandatory, others are
22 - hpd-gpios: References to the GPIOs that control the HDMI hot-plug
23 detection pins, one per HDMI input. The active flag indicates the GPIO
24 level that enables hot-plug detection.
28 Documentation/devicetree/bindings/media/video-interfaces.txt. The port nodes
32 ------------------------------------------------------------
33 HDMI 0 0, 1
40 - reset-gpios: Reference to the GPIO connected to the device's reset pin.
41 - default-input: Select which input is selected after reset.
42 - reg-names : Names of maps with programmable addresses.
43 It can contain any map needing a non-default address.
46 "rep", "edid", "hdmi", "test", "cp", "vdp"
50 The following three properties are defined in video-interfaces.txt and are
53 - hsync-active: Horizontal synchronization polarity. Defaults to active low.
54 - vsync-active: Vertical synchronization polarity. Defaults to active low.
55 - pclk-sample: Pixel clock polarity. Defaults to output on the falling edge.
57 If none of hsync-active, vsync-active and pclk-sample is specified the
65 * The edid page will be accessible @ 0x66 on the I2C bus. All
69 reg-names = "main", "edid";
71 reset-gpios = <&ioexp 0 GPIO_ACTIVE_LOW>;
72 hpd-gpios = <&ioexp 2 GPIO_ACTIVE_HIGH>;
74 #address-cells = <1>;
75 #size-cells = <0>;
77 default-input = <0>;
85 remote-endpoint = <&ccdc_in>;