Lines Matching +full:pre +full:- +full:set
1 * Texas Instruments - drv260x Haptics driver family
4 - compatible - One of:
5 "ti,drv2604" - DRV2604
6 "ti,drv2605" - DRV2605
7 "ti,drv2605l" - DRV2605L
8 - reg - I2C slave address
9 - vbat-supply - Required supply regulator
10 - mode - Power up mode of the chip (defined in include/dt-bindings/input/ti-drv260x.h)
11 DRV260X_LRA_MODE - Linear Resonance Actuator mode (Piezoelectric)
12 DRV260X_LRA_NO_CAL_MODE - This is a LRA Mode but there is no calibration
15 DRV260X_ERM_MODE - Eccentric Rotating Mass mode (Rotary vibrator)
16 - library-sel - These are ROM based waveforms pre-programmed into the IC.
17 This should be set to set the library to use at power up.
18 (defined in include/dt-bindings/input/ti-drv260x.h)
19 DRV260X_LIB_EMPTY - Do not use a pre-programmed library
20 DRV260X_ERM_LIB_A - Pre-programmed Library
21 DRV260X_ERM_LIB_B - Pre-programmed Library
22 DRV260X_ERM_LIB_C - Pre-programmed Library
23 DRV260X_ERM_LIB_D - Pre-programmed Library
24 DRV260X_ERM_LIB_E - Pre-programmed Library
25 DRV260X_ERM_LIB_F - Pre-programmed Library
26 DRV260X_LIB_LRA - Pre-programmed LRA Library
29 - enable-gpio - gpio pin to enable/disable the device.
30 - vib-rated-mv - The rated voltage of the actuator in millivolts.
31 If this is not set then the value will be defaulted to
33 - vib-overdrive-mv - The overdrive voltage of the actuator in millivolts.
34 If this is not set then the value will be defaulted to
41 vbat-supply = <&vbat>;
42 enable-gpio = <&gpio1 28 GPIO_ACTIVE_HIGH>;
44 library-sel = <DRV260X_LIB_LRA>;
45 vib-rated-mv = <3200>;
46 vib-overdrive-mv = <3200>;