Lines Matching +full:high +full:- +full:dynamic

8 -------------------
10 - #address-cells - should be <3>. Read more about addresses below.
11 - #size-cells - should be <0>.
12 - compatible - name of the I3C master controller driving the I3C bus
16 The node describing an I3C bus should be named i3c-master.
19 -------------------
24 - i3c-scl-hz: frequency of the SCL signal used for I3C transfers.
27 - i2c-scl-hz: frequency of the SCL signal used for I2C transfers.
40 --------------------------------------
41 - reg: contains 3 cells
52 * 1: I2C device does not have a 50 ns spike filter but supports high
55 to high frequencies
56 * 3-7: reserved
63 * 0-15: reserved
65 The I2C node unit-address should always match the first cell of the reg
66 property: <device-type>@<i2c-address>.
71 All I3C devices are supposed to support DAA (Dynamic Address Assignment), and
80 dynamic address before the DAA takes place (so that other devices on the bus
81 can't take this dynamic address).
83 The I3C device should be names <device-type>@<static-i2c-address>,<i3c-pid>,
84 where device-type is describing the type of device connected on the bus
85 (gpio-controller, sensor, ...).
88 -------------------
89 - reg: contains 3 cells
94 contains the manufacturer ID left-shifted by 1.
96 left-shifted by 16, the instance ID left-shifted
102 -------------------
103 - assigned-address: dynamic address to be assigned to this device. This
110 i3c-master@d040000 {
111 compatible = "cdns,i3c-master";
113 clock-names = "pclk", "sysclk";
116 #address-cells = <3>;
117 #size-cells = <0>;
118 i2c-scl-hz = <100000>;
129 assigned-address = <0xa>;