Lines Matching +full:host +full:- +full:wakeup

8 -----------------------------
10 - #address-cells  - should be <1>. Read more about addresses below.
11 - #size-cells     - should be <0>.
12 - compatible      - name of I2C bus controller
21 -----------------------------
26 - clock-frequency
29 - i2c-bus
31 	devices and non-I2C devices, the 'i2c-bus' subnode can be used for
32 	populating I2C devices. If the 'i2c-bus' subnode is present, only
34 	'#address-cells' and '#size-cells' must be defined under this subnode
37 - i2c-scl-falling-time-ns
41 - i2c-scl-internal-delay-ns
44 - i2c-scl-rising-time-ns
48 - i2c-sda-falling-time-ns
52 - i2c-analog-filter
55 - i2c-digital-filter
58 - i2c-digital-filter-width-ns
60 	(i2c-digital-filter). This width is specified in nanoseconds.
62 - i2c-analog-filter-cutoff-frequency
63 	Frequency that the analog filter (i2c-analog-filter) uses to distinguish
66 	a low-pass analog filter). Typical value should be above the normal
67 	i2c bus clock frequency (clock-frequency).
70 - multi-master
73 	all the time, for example. Can not be combined with 'single-master'.
75 - pinctrl
79 - scl-gpios
82 - sda-gpios
85 - single-master
88 	Can not be combined with 'multi-master'.
90 - smbus
95 - smbus-alert
96 	states that the optional SMBus-Alert feature apply to this bus.
98 - mctp-controller
103 --------------------------------------
105 - compatible
108 - reg
118 --------------------------------------
123 - host-notify
124 	device uses SMBus host notify protocol instead of interrupt line.
126 - interrupts
129 - interrupt-names
130 	"irq", "wakeup" and "smbus_alert" names are recognized by I2C core,
133 - reg-names
137 - wakeup-source
138 	device can be used as a wakeup source.
144 Alternatively, devices supporting SMBus Host Notify, and connected to
145 adapters that support this feature, may use "host-notify" property. I2C
146 core will create a virtual interrupt for Host Notify and assign it as
149 Also, if device is marked as a wakeup source, I2C core will set up "wakeup"
150 interrupt for the device. If "wakeup" interrupt name is not present in the
151 binding, then primary interrupt will be used as wakeup interrupt.