Lines Matching +full:sync +full:- +full:in +full:- +full:gpios

4 be used only in input mode. The Spreadtrum platform has 2 EIC controllers,
5 one is in digital chip, and another one is in PMIC. The digital chip EIC
6 controller contains 4 sub-modules: EIC-debounce, EIC-latch, EIC-async and
7 EIC-sync. But the PMIC EIC controller contains only one EIC-debounce sub-
10 The EIC-debounce sub-module provides up to 8 source input signal
12 stable status (millisecond resolution) and a single-trigger mechanism
13 is introduced into this sub-module to enhance the input event detection
14 reliability. In addition, this sub-module's clock can be shut off
19 The EIC-latch sub-module is used to latch some special power down signals
20 and generate interrupts, since the EIC-latch does not depend on the APB
23 The EIC-async sub-module uses a 32kHz clock to capture the short signals
26 The EIC-sync is similar with GPIO's input function, which is a synchronized
31 - compatible: Should be one of the following:
32   "sprd,sc9860-eic-debounce",
33   "sprd,sc9860-eic-latch",
34   "sprd,sc9860-eic-async",
35   "sprd,sc9860-eic-sync",
36   "sprd,sc2731-eic".
37 - reg: Define the base and range of the I/O address space containing
39 - gpio-controller: Marks the device node as a GPIO controller.
40 - #gpio-cells: Should be <2>. The first cell is the gpio number and
42 - interrupt-controller: Marks the device node as an interrupt controller.
43 - #interrupt-cells: Should be <2>. Specifies the number of cells needed
45 - interrupts: Should be the port interrupt shared by all the gpios.
49 		compatible = "sprd,sc9860-eic-debounce";
51 		gpio-controller;
52 		#gpio-cells = <2>;
53 		interrupt-controller;
54 		#interrupt-cells = <2>;
59 		compatible = "sprd,sc9860-eic-latch";
61 		gpio-controller;
62 		#gpio-cells = <2>;
63 		interrupt-controller;
64 		#interrupt-cells = <2>;
69 		compatible = "sprd,sc9860-eic-async";
71 		gpio-controller;
72 		#gpio-cells = <2>;
73 		interrupt-controller;
74 		#interrupt-cells = <2>;
79 		compatible = "sprd,sc9860-eic-sync";
81 		gpio-controller;
82 		#gpio-cells = <2>;
83 		interrupt-controller;
84 		#interrupt-cells = <2>;
89 		compatible = "sprd,sc2731-eic";
91 		interrupt-parent = <&sc2731_pmic>;
93 		gpio-controller;
94 		#gpio-cells = <2>;
95 		interrupt-controller;
96 		#interrupt-cells = <2>;