Lines Matching full:overlay

108 When a DT overlay that targets an FPGA Region is applied, the FPGA Region will
114  4. The Device Tree overlay is accepted into the live tree.
117 When the overlay is removed, the child nodes will be removed and the FPGA Region
133 The intended use is that a Device Tree overlay (DTO) can be used to reprogram an
140 FPGA.  After reprogramming is successful, the overlay is accepted into the live
178 	If this property is in an overlay targeting an FPGA region, it is a
200 In the example below, when an overlay is applied targeting fpga-region0,
205 firmware specified in the overlay is loaded to the FPGA using the FPGA manager
207 reenabled and the overlay makes it into the live device tree.  The child devices
209 and the overlay is rejected.  The overlay's ranges property maps the lwhps
246 Overlay contains:
281 a FPGA Region.  The target of the Device Tree Overlay is the FPGA Region.  Some
291    need to be controlled during full reconfiguration.  Before the overlay is
295    fpga-bridges property in the FPGA region or in the device tree overlay.
319  * The live DT prior to the overlay being added
320  * The DT overlay
331 The Device Tree Overlay will contain:
333    The insertion point where the contents of the overlay will go into the
368 DT Overlay contains:
396 DT Overlay contains:
437 The sequence that occurs when this overlay is similar to the above, the only