Lines Matching +full:imx27 +full:- +full:clock
5 wireless and mobile applications that use low-power technology.
11 - compatible: Should contain one of the following:
12 "fsl,imx1-weim"
13 "fsl,imx27-weim"
14 "fsl,imx51-weim"
15 "fsl,imx50-weim"
16 "fsl,imx6q-weim"
17 - reg: A resource specifier for the register space
19 - clocks: the clock, see the example below.
20 - #address-cells: Must be set to 2 to allow memory address translation
21 - #size-cells: Must be set to 1 to allow CS address passing
22 - ranges: Must be set up to reflect the memory layout with four
23 integer values for each chip-select line in use:
25 <cs-number> 0 <physical address of mapping> <size>
29 - fsl,weim-cs-gpr: For "fsl,imx50-weim" and "fsl,imx6q-weim" type of
37 ---------------------------------------------
47 - fsl,burst-clk-enable For "fsl,imx50-weim" and "fsl,imx6q-weim" type of
49 the weim bus should operate in Burst Clock Mode.
51 - fsl,continuous-burst-clk Make Burst Clock to output continuous clock.
52 Without this option Burst Clock will output clock
54 "fsl,burst-clk-enable" is set.
58 - fsl,weim-cs-timing: The timing array, contains timing values for the
62 For i.MX1, i.MX21 ("fsl,imx1-weim") there are two
64 For i.MX25, i.MX27, i.MX31 and i.MX35 ("fsl,imx27-weim")
66 For i.MX50, i.MX53 ("fsl,imx50-weim"),
67 i.MX51 ("fsl,imx51-weim") and i.MX6Q ("fsl,imx6q-weim")
71 Example for an imx6q-sabreauto board, the NOR flash connected to the WEIM:
74 compatible = "fsl,imx6q-weim";
77 #address-cells = <2>;
78 #size-cells = <1>;
80 fsl,weim-cs-gpr = <&gpr>;
83 compatible = "cfi-flash";
85 #address-cells = <1>;
86 #size-cells = <1>;
87 bank-width = <2>;
88 fsl,weim-cs-timing = <0x00620081 0x00000001 0x1c022000
93 Example for an imx6q-based board, a multi-chipselect device connected to WEIM:
99 compatible = "fsl,imx6q-weim";
102 #address-cells = <2>;
103 #size-cells = <1>;
108 fsl,weim-cs-gpr = <&gpr>;
114 fsl,weim-cs-timing = <0x024400b1 0x00001010 0x20081100