Lines Matching +full:ahci +full:- +full:port

1 * AHCI SATA Controller
3 SATA nodes are defined to describe on-chip Serial ATA controllers.
6 It is possible, but not required, to represent each port as a sub-node.
7 It allows to enable each port independently when dealing with multiple
11 - compatible : compatible string, one of:
12 - "brcm,iproc-ahci"
13 - "hisilicon,hisi-ahci"
14 - "cavium,octeon-7130-ahci"
15 - "ibm,476gtr-ahci"
16 - "marvell,armada-380-ahci"
17 - "marvell,armada-3700-ahci"
18 - "snps,dwc-ahci"
19 - "snps,spear-ahci"
20 - "generic-ahci"
21 - interrupts : <interrupt mapping for SATA IRQ>
22 - reg : <registers mapping>
24 Please note that when using "generic-ahci" you must also specify a SoC specific
26 compatible = "manufacturer,soc-model-ahci", "generic-ahci";
29 - dma-coherent : Present if dma operations are coherent
30 - clocks : a list of phandle + clock specifier pairs
31 - resets : a list of phandle + reset specifier pairs
32 - target-supply : regulator for SATA target power
33 - phy-supply : regulator for PHY power
34 - phys : reference to the SATA PHY node
35 - phy-names : must be "sata-phy"
36 - ahci-supply : regulator for AHCI controller
37 - ports-implemented : Mask that indicates which ports that the HBA supports
42 Required properties when using sub-nodes:
43 - #address-cells : number of cells to encode an address
44 - #size-cells : number of cells representing the size of an address
46 Sub-nodes required properties:
47 - reg : the port number
49 - phys : reference to the SATA PHY node
50 - target-supply : regulator for SATA target power
54 compatible = "snps,spear-ahci";
59 With sub-nodes:
61 compatible = "marvell,berlin2q-achi", "generic-ahci";
65 #address-cells = <1>;
66 #size-cells = <0>;
68 sata0: sata-port@0 {
71 target-supply = <&reg_sata0>;
74 sata1: sata-port@1 {
77 target-supply = <&reg_sata1>;;