Lines Matching full:set
159 * If use_flow_id_toeplitz_clfy is set and lmac_peer_id_'sb
163 * If use_flow_id_toeplitz_clfy is set and lmac_peer_id_msb
187 * pkt_selection_fp_... bit is set
191 * pkt_selection_fp_... bit is set
194 * If set, for multicast packets, multicast echo check (i.e.
200 * If set, WDS learning detection based on SA search and notification
206 * If set, intra-BSS routing detection is enabled
222 * This is set by SW for peers which are being handled by a
256 * this field will be set to 0
257 * If set to one use EPD instead of LPD
258 * In case of ndp or phy_err, this field will never be set.
262 * this field will be set to 0
264 * When set, all frames (data only ?) shall be encrypted. If
265 * not, RX CRYPTO shall set an error flag.
270 * this field will be set to 0
277 * Field only valid when key_type is set to wep_varied_width.
282 * When set, the BSSID of the incoming frame matched one of
285 * Field only valid when bssid_hit is set.
290 * Field only valid when mpdu_qos_control_valid is set
307 * When set, the received frame was an NDP frame, and thus
310 * When set, a PHY error was received before MAC received any
314 * When set, a PHY error was received before MAC received the
318 * Set when RXPCU detected a version error in the Frame control
322 * When set, AST based lookup for this frame has found a valid
326 * When set, a ranging NDPA or a ranging NDP was received.
342 * this field will be set to 0
343 * This field indicates a unique peer identifier. It is set
347 * When set, the field Mpdu_Frame_control_field has valid information
350 * When set, the field Mpdu_duration_field has valid information
353 * When set, the fields mac_addr_adx_..... have valid information
357 * When set, the fields mpdu_sequence_control_field and mpdu_sequence_number
360 * not be set.
364 * When set, the field mpdu_qos_control_field, mpdu_ht_control has valid
366 * will not be set.
370 * When set, the encryption related info fields, like IV and
372 * For MPDUs that are not encrypted, this will not be set.
376 * Field only valid when Mpdu_sequence_control_valid is set
377 * AND Fragment_flag is set. The fragment number from the 802.11 header
386 * Field only valid when Mpdu_frame_control_valid is set
387 * Set if the from DS bit is set in the frame control.
391 * Field only valid when Mpdu_frame_control_valid is set
392 * Set if the to DS bit is set in the frame control.
396 * Field only valid when Mpdu_frame_control_valid is set.
400 * Field only valid when Mpdu_frame_control_valid is set.
401 * Retry bit from the frame control. Only valid when first_msdu is set
404 * Field only valid when Mpdu_sequence_control_valid is set.
409 * Field only valid when Frame_encryption_info_valid is set
412 * Set if new RX_PEER_ENTRY TLV follows. If clear, RX_PEER_ENTRY
418 * RXPCU will also ensure that this bit is NOT set. CRYPTO for that
452 * Set when no 802.11 to nwifi/ethernet hdr conversion is done
459 * and last_mpdu are set in the MSDU then this is a not an
461 * A-MPDU shall have both first_mpdu and last_mpdu bits set to
463 * is set.
466 * Multicast / broadcast indicator. Only set when the MAC
467 * address 1 bit 0 is set indicating mcast/bcast and the BSSID
468 * matches one of the 4 BSSID registers. Only set when
469 * first_msdu is set.
472 * Only valid when first_msdu is set. Indicates no AST matching
476 * Only valid when first_msdu is set. Indicates an unsuccessful
480 * Power management bit set in the 802.11 header. Only set
481 * when first_msdu is set.
484 * Set if packet is not a non-QoS data frame. Only set when
485 * first_msdu is set.
488 * Set if frame type indicates either null data or QoS null
489 * data format. Only set when first_msdu is set.
492 * Set if packet is a management packet. Only set when
493 * first_msdu is set.
496 * Set if packet is a control packet. Only set when first_msdu
497 * is set.
500 * Set if more bit in frame control is set. Only set when
501 * first_msdu is set.
504 * Set if the EOSP (end of service period) bit in the QoS
505 * control field is set. Only set when first_msdu is set.
512 * Set if the order bit in the frame control is set. Only
513 * set when first_msdu is set.
539 * address valid bit is set
565 * If set, Rx OLE shall convert Address1 and Address2 of received
570 * valid bit is set
573 * If not set, RXDMA shall perform error-routing for WDS packets
806 * set. This field is taken directly from the length field of the
822 * 'RXOLE_R0_FISA_CTRL. CHKSUM_CUM_IP_LEN_EN' is set
837 * da_offset field is valid. This will be set to 0 in case
841 * sa_offset field is valid. This will be set to 0 in case
846 * extracted from LLC/SNAP, set to zero if SNAP is not
878 * Set if the to DS bit is set in the frame control.
890 * Field Only valid if da_is_valid is set. Indicates the DA address
899 * last_msdu are set in the MSDU then this is a non-aggregated MSDU
901 * first_mpdu and last_mpdu bits set to 0.
905 * valid when last_msdu is set.
908 * Set if the from DS bit is set in the frame control.
943 * When set, this is a Mesh (11s) STA.
946 * Set by RXOLE if it stripped 4-bytes of C-VLAN Tag from the
950 * Set by RXOLE if it stripped 4-bytes of S-VLAN Tag from the
955 * set when either the more_frag bit is set in the frame control
956 * or the fragment number is not zero. Only set when first_msdu
957 * is set.
1011 * The key ID octet from the IV. Only valid when first_msdu is set.
1025 * If intra_bss is set, copied by RXOLE from 'ADDR_SEARCH_ENTRY'
1031 * If set, this packet is a multicast echo, i.e. the DA is
1036 * If set, this packet has an SA search failure with WDS learning
1041 * If set, this packet's SA 'Sw_peer_id' mismatches the 'Sw_peer_id'
1047 * If set, the AST timestamp for this packet's SA is older
1058 * When set, use STBC transmission rates.
1061 * Set if IPv4/v6 packet is using IPsec ESP.
1068 * ipv6_proto is set.
1071 * Set if IPv4/v6 packet is using IPsec AH
1076 * if either ipv4_proto or ipv6_proto is set to 1) or indicates
1079 * tcp_proto or udp_proto is set). The value 0 indicates that
1092 * Set if L2 layer indicates IPv4 protocol.
1095 * Set if L2 layer indicates IPv6 protocol.
1098 * Set if the ipv4_proto or ipv6_proto are set and the IP protocol
1102 * Set if the ipv4_proto or ipv6_proto are set and the IP protocol
1106 * Indicates that either the IP More frag bit is set or IP frag
1107 * number is non-zero. If set indicates that this is a fragmented
1111 * Set if only the TCP Ack bit is set in the TCP flags and if
1141 * When set, this MSDU includes the 'Mesh Control' field
1146 * For IPv4, this is the 8 bit protocol field set). For IPv6 this
1196 * If set indicates that the RX packet data, RX header data,
1239 * and last_mpdu are set in the MSDU then this is a not an
1241 * A-MPDU shall have both first_mpdu and last_mpdu bits set to
1243 * is set.
1246 * Multicast / broadcast indicator. Only set when the MAC
1247 * address 1 bit 0 is set indicating mcast/bcast and the BSSID
1248 * matches one of the 4 BSSID registers. Only set when
1249 * first_msdu is set.
1252 * Only valid when first_msdu is set. Indicates no AST matching
1256 * Only valid when first_msdu is set. Indicates an unsuccessful
1260 * Power management bit set in the 802.11 header. Only set
1261 * when first_msdu is set.
1264 * Set if packet is not a non-QoS data frame. Only set when
1265 * first_msdu is set.
1268 * Set if frame type indicates either null data or QoS null
1269 * data format. Only set when first_msdu is set.
1272 * Set if packet is a management packet. Only set when
1273 * first_msdu is set.
1276 * Set if packet is a control packet. Only set when first_msdu
1277 * is set.
1280 * Set if more bit in frame control is set. Only set when
1281 * first_msdu is set.
1284 * Set if the EOSP (end of service period) bit in the QoS
1285 * control field is set. Only set when first_msdu is set.
1288 * Set if number of MSDUs in A-MSDU is above a threshold or if the
1293 * Set if the order bit in the frame control is set. Only
1294 * set when first_msdu is set.
1309 * Set by RXPCU if the expected MPDU length does not correspond
1349 * fragmented. If set the FW should look at the rx_frag_info
1382 * If set indicates that the RX packet data, RX header data, RX