Lines Matching +full:packet +full:- +full:based
1 /* SPDX-License-Identifier: BSD-3-Clause-Clear */
3 * Copyright (c) 2018-2021 The Linux Foundation. All rights reserved.
4 * Copyright (c) 2021-2022 Qualcomm Innovation Center, Inc. All rights reserved.
169 * Indication to Rx OLE to enable REO destination routing based
200 * If set, WDS learning detection based on SA search and notification
202 * field in address search failure cache-only entry should
206 * If set, intra-BSS routing detection is enabled
213 * buffers shall be disabled based on an RXDMA configuration,
223 * host SW/accelerator subsystem that also handles packet
224 * uffer management for WiFi-to-PPE routing.
227 * by a different subsystem, completely disabling WiFi-to-PPE
303 * SW processes frames based on certain classifications. Values
322 * When set, AST based lookup for this frame has found a valid
437 * received MPDU in the PPDU and this MPDU gets filtered-in,
446 * Received frame was part of an A-MPDU.
460 * A-MPDU frame but a stand alone MPDU. Interior MPDU in an
461 * A-MPDU shall have both first_mpdu and last_mpdu bits set to
484 * Set if packet is not a non-QoS data frame. Only set when
492 * Set if packet is a management packet. Only set when
496 * Set if packet is a control packet. Only set when first_msdu
516 * U-APSD trigger frame
524 * MPDU is a directed packet which means that the RA matched
547 * RXOLE uses this to determine intra-BSS routing.
550 * Opaque service code between PPE and Wi-Fi
566 * data frames to multi-link addresses during decapsulation to eth/nwifi
569 * Multi-link receiver address1,2. Only valid when corresponding
573 * If not set, RXDMA shall perform error-routing for WDS packets
793 * SW processes frames based on certain classifications. Values
807 * A-MPDU delimiter or the preamble length field for non-A-MPDU
838 * of a dynamic A-MSDU when DA is compressed.
842 * of a dynamic A-MSDU when SA is compressed.
845 * The 16-bit type value indicating the type of L3 later
898 * Indicates the first MSDU of A-MSDU. If both first_msdu and
899 * last_msdu are set in the MSDU then this is a non-aggregated MSDU
900 * frame: normal MPDU. Interior MSDU in an A-MSDU shall have both
904 * Indicates the last MSDU of the A-MSDU. MPDU end status is only
919 * Based on a register configuration in RXOLE, this field will
946 * Set by RXOLE if it stripped 4-bytes of C-VLAN Tag from the
947 * packet
950 * Set by RXOLE if it stripped 4-bytes of S-VLAN Tag from the
951 * packet
975 * the previous packet with the same flow id
1004 * A-MSDU could not be properly de-agregated.
1014 * Opaque service code between PPE and Wi-Fi
1020 * This packet needs intra-BSS routing by SW as the 'vdev_id'
1026 * to support intra-BSS routing with multi-chip multi-link
1027 * operation. This indicates into which chip's TCL the packet should be
1031 * If set, this packet is a multicast echo, i.e. the DA is
1036 * If set, this packet has an SA search failure with WDS learning
1041 * If set, this packet's SA 'Sw_peer_id' mismatches the 'Sw_peer_id'
1042 * of the peer through which the packet was got, indicating
1047 * If set, the AST timestamp for this packet's SA is older
1054 * This field is still valid for MPDU frames without A-MSDU.
1061 * Set if IPv4/v6 packet is using IPsec ESP.
1066 * offset in bytes from the start of the packet after
1071 * Set if IPv4/v6 packet is using IPsec AH
1107 * number is non-zero. If set indicates that this is a fragmented
1108 * IP packet.
1119 * 0 - Toeplitz hash of 2-tuple (IP source address, IP
1121 * 1 - Toeplitz hash of 4-tuple (IP source address,
1124 * 2 - Toeplitz of flow_id
1125 * 3 - Zero is used
1128 * Fixed 20-byte IPv4 header or 40-byte IPv6 header parsed
1129 * fully within first 256 bytes of the packet
1134 * bytes of the packet
1137 * Fixed 20-byte TCP (excluding TCP options) or 8-byte UDP
1138 * header parsed fully within first 256 bytes of the packet
1151 * 2 bytes of C-VLAN Tag Control Information from WHO_L2_LLC
1154 * 2 bytes of S-VLAN Tag Control Information from WHO_L2_LLC
1192 * 0 - spatial stream not used for this reception
1193 * 1 - spatial stream used for this reception
1196 * If set indicates that the RX packet data, RX header data,
1199 * are all valid. This bit is in the last 64-bit of the descriptor
1203 * Toeplitz hash of 5-tuple
1205 * destination port, L4 protocol} in case of non-IPSec.
1207 * In case of IPSec - Toeplitz hash of 4-tuple
1226 * IPv4/IPv6 - Either, Toeplitz hash computed over 2-tuple
1228 * hash computed over 4-tuple IPv4 or IPv6 src/dest addresses
1231 * is the one used for hash-based REO routing (see use_flow_id_toeplitz_clfy
1240 * A-MPDU frame but a stand alone MPDU. Interior MPDU in an
1241 * A-MPDU shall have both first_mpdu and last_mpdu bits set to
1264 * Set if packet is not a non-QoS data frame. Only set when
1272 * Set if packet is a management packet. Only set when
1276 * Set if packet is a control packet. Only set when first_msdu
1288 * Set if number of MSDUs in A-MSDU is above a threshold or if the
1329 * Indicates that an A-MSDU with 'from DS = 0' had an SA mismatching
1330 * TA or an A-MDU with 'to DS = 0' had a DA mismatching RA
1333 * Indicates that RX packet is not decrypted as Crypto is busy
1334 * with TX packet processing.
1342 * MPDU is a directed packet which means that the RA matched
1353 * Indicates that the MPDU was pre-maturely terminated
1382 * If set indicates that the RX packet data, RX header data, RX