Lines Matching +full:mode +full:- +full:capable

51 .Fn ieee80211_setmode "struct ieee80211com *ic" "enum ieee80211_phymode mode"
58 .Fa "struct ieee80211com *ic" "int rate" "enum ieee80211_phymode mode"
72 layer for protocol services but devices that off-load functionality
80 These interfaces have an operating mode
181 functions are device-independent handlers for
188 function is called from within the 802.11 stack to change the mode
194 function returns the PHY mode required for use with the channel
206 sub-type, for the device
208 running in PHY mode
209 .Fa mode .
215 sub-type.
218 The virtual radio architecture splits state between a single per-device
225 as read-only.
240 and should be extended with any driver-private state.
244 data structures and should be exploited to maintain driver-private state
255 Long-lasting references to a node are counted to guard against
265 fill-in and/or override to take control of certain operations.
275 The driver is expected to allocate and setup any device-private
279 structure must be pre-initialized with state required to setup the
282 .Bl -tag -width ic_channels
288 Table of channels the device is capable of operating on.
304 .Bl -tag -width ic_channels
306 Create a vap instance of the specified type (operating mode).
308 Drivers that support multi-bssid operation may honor the requested BSSID
340 Update hardware for a change in the promiscuous mode setting.
343 Update driver/device state for association to a new AP (in station mode)
344 or when a new station associates (e.g. in AP mode).
385 The default method ages frames on the power-save queue (in AP mode)
386 and pending frames in the receive reorder queues (for stations using A-MPDU).
433 Drivers that off-load scan work to firmware typically use this method
434 to trigger per-channel scan activity.
456 Check if transmit A-MPDU should be enabled for the specified station and AC.
457 The default method checks a per-AC traffic rate against a per-vap
458 threshold to decide if A-MPDU should be enabled.
459 This method also rate-limits ADDBA requests so that requests are not
462 Request A-MPDU transmit aggregation.
466 for handling transmit A-MPDU.
469 needed for doing transmit A-MPDU.
471 Shutdown an A-MPDU transmit stream for the specified station and AC.
476 Prepare to receive A-MPDU data from the specified station for the TID.
478 Terminate receipt of A-MPDU data from the specified station for the TID.
485 .Bl -enum
504 worry about being re-entered.
530 .Bl -tag -width IEEE80211_C_8023ENCAP
532 Device is capable of operating in station (aka Infrastructure) mode.
534 Device requires 802.3-encapsulated frames be passed for transmit.
539 Device supports Atheros Fast-Frames.
541 Device supports Atheros Dynamic Turbo mode.
543 Device is capable of operating in adhoc/IBSS mode.
545 Device supports dynamic power-management (aka power save) in station mode.
547 Device is capable of operating as an Access Point in Infrastructure mode.
549 Device is capable of operating in Adhoc Demo mode.
550 In this mode the device is used purely to send/receive raw 802.11 frames.
561 Device is capable of operating in monitor mode.
566 but the device must be capable of detecting radar events.
568 Device is capable of operating in MeshBSS (MBSS) mode
581 Device supports transmit/receive of 4-address frames.
587 Device is capable of operating in TDMA mode.
593 will fall-back to software support when a device is not capable
595 This can be done on a per-key basis.
602 .Bl -tag -width IEEE80211_C_8023ENCAP
608 Device supports hardware AES-OCB cipher.
610 Device supports hardware AES-CCM cipher.
623 .Bl -tag -width IEEE80211_C_8023ENCAP
641 Device supports 1-2 spatial streams for STBC receive.
643 Device supports 1-3 spatial streams for STBC receive.
645 Device supports A-MSDU frames up to 7935 octets.
647 Device supports A-MSDU frames up to 3839 octets.
655 Device supports L-SIG TXOP protection.
657 Device supports A-MPDU aggregation.
658 Note that any 802.11n compliant device must support A-MPDU receive
661 of A-MPDU frames.
663 Device supports A-MSDU aggregation.
664 Note that any 802.11n compliant device must support A-MSDU receive
667 of A-MSDU frames.
707 .An -nosplit