Lines Matching +full:conversion +full:- +full:interval

72 layer for protocol services but devices that off-load functionality
155 If the conversion would be invalid, an error message is printed to the
181 functions are device-independent handlers for
206 sub-type, for the device
212 performs the reverse of this conversion, returning the bit rate (in 0.5Mbps
215 sub-type.
218 The virtual radio architecture splits state between a single per-device
225 as read-only.
240 and should be extended with any driver-private state.
244 data structures and should be exploited to maintain driver-private state
255 Long-lasting references to a node are counted to guard against
265 fill-in and/or override to take control of certain operations.
275 The driver is expected to allocate and setup any device-private
279 structure must be pre-initialized with state required to setup the
282 .Bl -tag -width ic_channels
304 .Bl -tag -width ic_channels
308 Drivers that support multi-bssid operation may honor the requested BSSID
385 The default method ages frames on the power-save queue (in AP mode)
386 and pending frames in the receive reorder queues (for stations using A-MPDU).
433 Drivers that off-load scan work to firmware typically use this method
434 to trigger per-channel scan activity.
456 Check if transmit A-MPDU should be enabled for the specified station and AC.
457 The default method checks a per-AC traffic rate against a per-vap
458 threshold to decide if A-MPDU should be enabled.
459 This method also rate-limits ADDBA requests so that requests are not
462 Request A-MPDU transmit aggregation.
466 for handling transmit A-MPDU.
469 needed for doing transmit A-MPDU.
471 Shutdown an A-MPDU transmit stream for the specified station and AC.
476 Prepare to receive A-MPDU data from the specified station for the TID.
478 Terminate receipt of A-MPDU data from the specified station for the TID.
485 .Bl -enum
504 worry about being re-entered.
530 .Bl -tag -width IEEE80211_C_8023ENCAP
534 Device requires 802.3-encapsulated frames be passed for transmit.
539 Device supports Atheros Fast-Frames.
545 Device supports dynamic power-management (aka power save) in station mode.
581 Device supports transmit/receive of 4-address frames.
593 will fall-back to software support when a device is not capable
595 This can be done on a per-key basis.
602 .Bl -tag -width IEEE80211_C_8023ENCAP
608 Device supports hardware AES-OCB cipher.
610 Device supports hardware AES-CCM cipher.
623 .Bl -tag -width IEEE80211_C_8023ENCAP
633 Device supports Short Guard Interval on 20MHz channels.
635 Device supports Short Guard Interval on 40MHz channels.
641 Device supports 1-2 spatial streams for STBC receive.
643 Device supports 1-3 spatial streams for STBC receive.
645 Device supports A-MSDU frames up to 7935 octets.
647 Device supports A-MSDU frames up to 3839 octets.
655 Device supports L-SIG TXOP protection.
657 Device supports A-MPDU aggregation.
658 Note that any 802.11n compliant device must support A-MPDU receive
661 of A-MPDU frames.
663 Device supports A-MSDU aggregation.
664 Note that any 802.11n compliant device must support A-MSDU receive
667 of A-MSDU frames.
707 .An -nosplit