Lines Matching +full:enable +full:- +full:ssc

65 .Bl -enum
68 referred to as sub-mode 00 below.
84 .Sh SUB-MODES
85 The sub-modes differ in the action taken when the device is closed:
86 .Bl -tag -width XXXX
110 block-size modes.
112 .Tn QIC Ns -type
113 devices run in fixed block-size mode, where most nine-track tapes and
114 many new cartridge formats allow variable block-size.
116 .Bl -inset
117 .It Variable block-size:
136 process to read will immediately hit the file mark and receive an end-of-file notification.
137 .It Fixed block-size:
146 and vice-versa.
156 process to read if in no-rewind mode.)
173 The problem with that behavior, though, is that it hides the actual on-tape
181 .Bl -tag -width 12
198 .Bl -tag -width 12
246 .Dq mt param -l
250 .Dq mt param -s
261 .Bl -tag -width 5n
270 See the SSC-5 spec (available at t10.org), specifically the section on the
290 This is a read-only parameter, and is set to 1 if the tape drive supports
295 As of SSC-5r03 (available at t10.org), the protection method values are:
296 .Bl -tag -width 3n
300 Reed-Solomon CRC, 4 bytes in length.
307 If set to 1, enable logical block protection on writes.
311 If set to 1, enable logical block protection on reads.
315 If set to 1, enable logical block protection on the RECOVER BUFFERED DATA
328 For newer tape drives that claim to support the SPC-4
364 To set timeouts after boot, the per-instance timeout values, for example:
368 If a tape drive arrives after boot, the global tunables or per-instance
373 .Bl -tag -compact
395 .Bl -tag -compact
422 .Bl -tag -width /dev/[n][e]sa[0-9] -compact
423 .It Pa /dev/[n][e]sa[0-9]
461 .An -nosplit
486 .Tn SCSI-1