Lines Matching +full:1 +full:- +full:based
1 .\" Copyright (c) 2011-2016, Chelsio Inc
7 .\" 1. Redistributions of source code must retain the above copyright notice,
37 .Nd "Chelsio T4-, T5-, and T6-based 100Gb, 40Gb, 25Gb, 10Gb, and 1Gb Ethernet VF driver"
42 .Bd -ragged -offset indent
50 .Bd -literal -offset indent
57 based on the Chelsio Terminator 4, Terminator 5, and Terminator 6 ASICs
69 driver uses different names for devices based on the associated ASIC:
70 .Bl -column -offset indent "ASIC" "Port Name"
93 based on the T6 ASIC:
95 .Bl -bullet -compact
97 Chelsio T6225-CR
99 Chelsio T6225-SO-CR
101 Chelsio T62100-LP-CR
103 Chelsio T62100-SO-CR
105 Chelsio T62100-CR
110 driver supports Virtual Functions on 40Gb, 10Gb and 1Gb Ethernet adapters
111 based on the T5 ASIC:
113 .Bl -bullet -compact
115 Chelsio T580-CR
117 Chelsio T580-LP-CR
119 Chelsio T580-LP-SO-CR
121 Chelsio T560-CR
123 Chelsio T540-CR
125 Chelsio T540-LP-CR
127 Chelsio T522-CR
129 Chelsio T520-LL-CR
131 Chelsio T520-CR
133 Chelsio T520-SO
135 Chelsio T520-BT
137 Chelsio T504-BT
142 driver supports Virtual Functions on 10Gb and 1Gb Ethernet adapters based
145 .Bl -bullet -compact
147 Chelsio T420-CR
149 Chelsio T422-CR
151 Chelsio T440-CR
153 Chelsio T420-BCH
155 Chelsio T440-BCH
157 Chelsio T440-CH
159 Chelsio T420-SO
161 Chelsio T420-CX
163 Chelsio T420-BT
165 Chelsio T404-BT
172 .Bl -tag -width indent
183 The holdoff timer list has the values 1, 5, 10, 50, 100, and 200
186 The default value is 1 which means the timer value is 5us.
190 Packet-count index value used to delay interrupts.
191 The packet-count list has the values 1, 8, 16, and 32 by default,
193 The default value is -1 which means packet counting is disabled and interrupts
194 are generated based solely on the holdoff timer value.
219 Bit 0 represents INTx (line interrupts), bit 1 MSI, and bit 2 MSI-X.
223 to attach if neither MSI nor MSI-X are enabled.
229 0-7 are all valid values.
231 A non-zero value ensures that writes from the hardware to a receive buffer are
233 The default is -1 which lets the driver pick a pad boundary.
238 The default is -1 which lets the driver decide.
239 0 or 1 explicitly disable or enable this feature.
241 1 allows the driver to lay down one or more mbufs within the receive buffer
255 Note that largest_rx_cluster merely establishes a ceiling -- the driver is
276 to 1
304 .An -nosplit