Lines Matching +full:pre +full:- +full:packaged

1 .\" Copyright (c) 2011-2016, Chelsio Inc
37 .Nd "Chelsio T4-, T5-, and T6-based 100Gb, 40Gb, 25Gb, 10Gb, and 1Gb Ethernet adapter driver"
42 .Bd -ragged -offset indent
49 .Bd -literal -offset indent
71 .Bl -column -offset indent "ASIC" "Port Name" "Parent Device"
83 adapter-wide MIBs under dev.t5nex.
85 dev.<port> for port MIBs and dev.<nexus> for adapter-wide MIBs.
94 .Bl -bullet -compact
96 Chelsio T6225-CR
98 Chelsio T6225-SO-CR
100 Chelsio T62100-LP-CR
102 Chelsio T62100-SO-CR
104 Chelsio T62100-CR
111 .Bl -bullet -compact
113 Chelsio T580-CR
115 Chelsio T580-LP-CR
117 Chelsio T580-LP-SO-CR
119 Chelsio T560-CR
121 Chelsio T540-CR
123 Chelsio T540-LP-CR
125 Chelsio T522-CR
127 Chelsio T520-LL-CR
129 Chelsio T520-CR
131 Chelsio T520-SO
133 Chelsio T520-BT
135 Chelsio T504-BT
142 .Bl -bullet -compact
144 Chelsio T420-CR
146 Chelsio T422-CR
148 Chelsio T440-CR
150 Chelsio T420-BCH
152 Chelsio T440-BCH
154 Chelsio T440-CH
156 Chelsio T420-SO
158 Chelsio T420-CX
160 Chelsio T420-BT
162 Chelsio T404-BT
173 .Bl -tag -width indent
212 Packet-count index value used to delay interrupts.
213 The packet-count list has the values 1, 8, 16, and 32 by default,
216 The default value is -1 which means packet counting is disabled and interrupts
242 Bit 0 represents INTx (line interrupts), bit 1 MSI, and bit 2 MSI-X.
247 -1 indicates the driver should determine whether to enable or disable PCIe RO.
251 The default is -1.
267 0-7 are all valid values.
269 A non-zero value ensures that writes from the hardware to a receive buffer are
271 The default is -1 which lets the driver pick a pad boundary.
275 -1 disables congestion feedback and is not recommended.
291 Settings can be displayed and controlled on a per-port basis via the
295 -1 (default) means driver should automatically pick a value.
298 Bit 0 enables RS FEC, bit 1 enables BASE-R FEC (aka Firecode FEC), bit
303 Settings can be controlled on a per-port basis via the
310 Settings can be displayed and controlled on a per-port basis via the
314 The default is -1 which lets the driver pick a value.
315 dev.<port>.X.autoneg is -1 for port and module combinations that do not support
320 The default is -1 which lets the driver decide.
332 Note that largest_rx_cluster merely establishes a ceiling -- the driver is
335 Select a pre-packaged device configuration file.
350 Each of these is a bit field with a bit for each sub-capability within the
423 .An -nosplit