Lines Matching +full:two +full:- +full:ethernet

46 .Bd -ragged -offset indent
53 .Bd -literal -offset indent
60 driver creates a logical link between two or more IEEE 802 networks
64 For example, it is possible to bridge Ethernet and 802.11 networks together,
65 but it is not possible to bridge Ethernet and Token Ring together.
88 Thus you can theoretically have two bridges on different machines with
97 has a non-zero value, the newly created bridge will inherit the MAC
98 address from its first member instead of choosing a random link-level
110 802.11-to-Ethernet bridge for wireless hosts, or traffic isolation.
145 Changing capabilities at run-time may cause NIC reinit and a link flap.
152 This can be used to multiplex the input of two or more interfaces into a single
156 that transmit the RX/TX signals out through two separate interfaces.
164 variable configures an IPv6 link-local address on
167 .Bd -literal -offset indent
172 .Bd -literal -offset indent
182 This means each member interface still has a separate link-local scope
186 aggregated link-local scope zone at the same time.
200 checks whether a link-local scoped IPv6 address is configured on
264 .Bl -tag -width ".Va net.link.bridge.pfil_onlyip"
266 Controls the handling of non-IP packets which are not passed to
272 to unconditionally pass all non-IP Ethernet frames.
312 is not run twice; these can be re-enabled if desired.
330 IPFW can filter Ethernet types using
331 .Cm mac-type
365 .Bl -bullet
415 that are doing IP-forwarding; in some of such cases it is better
456 802.11-to-Ethernet bridge (assuming the 802.11 interface is
457 in ad-hoc mode).
458 .Bd -literal -offset indent
466 .Bd -literal -offset indent
472 Consider a system with two 4-port Ethernet boards.
475 .Bd -literal -offset indent
493 .Bd -literal -offset indent
500 The bridge can tunnel Ethernet across an IP internet using the EtherIP
509 .Bd -literal -offset indent
528 .An -nosplit
546 driver currently supports only Ethernet and Ethernet-like (e.g., 802.11)