Lines Matching +full:memory +full:- +full:controller

1 .\" Copyright (c) 2006-2014 QLogic Corporation
35 .Bd -ragged -offset indent
43 .Bd -literal -offset indent
55 same controller.
62 .Bl -item -offset indent -compact
72 10/100/1000Mbps operation in full-duplex mode
74 10/100Mbps operation in half-duplex mode
80 .Bl -tag -width ".Cm 10baseT/UTP"
92 .Cm full-duplex
94 .Cm half-duplex
102 .Cm full-duplex
104 .Cm half-duplex
109 .Cm full-duplex
114 .Cm full-duplex
119 .Cm full-duplex
126 .Bl -tag -width ".Cm full-duplex"
127 .It Cm full-duplex
129 .It Cm half-duplex
142 .Bl -bullet -compact
144 QLogic NetXtreme II BCM5706 1000Base-SX
146 QLogic NetXtreme II BCM5706 1000Base-T
148 QLogic NetXtreme II BCM5708 1000Base-SX
150 QLogic NetXtreme II BCM5708 1000Base-T
152 QLogic NetXtreme II BCM5709 1000Base-SX
154 QLogic NetXtreme II BCM5709 1000Base-T
156 QLogic NetXtreme II BCM5716 1000Base-T
188 HP NC382m DP 1GbE Multifunction BL-c Adapter
196 .Bl -tag -width indent
209 Set the number of memory pages assigned to receive packets by the driver.
213 Set the number of memory pages assigned to transmit packets
220 Values from 0-100 are valid.
227 Values from 0-100 are valid.
228 Valid values are in the range from 0-100.
233 Values from 0-256 are valid.
239 Values from 0-256 are valid.
244 Values from 0-100 are valid.
251 Values from 0-100 are valid.
256 Values from 0-100 are valid.
262 Values from 0-100 are valid.
266 .Bl -diag
267 .It "bce%d: PCI memory allocation failed!"
271 .It "bce%d: Unsupported controller revision (%c%d)"
272 The driver does not support the controller revision in use.
273 .It "bce%d: Controller initialization failed!"
276 The driver could not access the controller NVRAM correctly.
278 The driver could not allocate DMA memory to setup the controllers
279 host memory data structures.
281 The driver could not create a network interface for the controller.
283 The driver could not access the PHY used by the controller.
302 The driver was unable to map memory into DMA addressable space required
303 by the controller.
307 The driver could not allocate a DMA tag for the controller's
309 .It "bce%d: Could not allocate status block DMA memory!"
310 The driver could not allocate DMA addressable memory for the controller's
312 .It "bce%d: Could not map status block DMA memory!"
313 The driver could not map the status block memory into the controller's DMA
316 The driver could not allocate a DMA tag for the controller's
318 .It "bce%d: Could not allocate statistics block DMA memory!"
319 The driver could not allocate DMA addressable memory for the controller's
321 .It "bce%d: Could not map statistics block DMA memory!"
322 The driver could not map the statistics block memory into the controller's DMA
325 The driver could not allocate a DMA tag for the controller's
327 .It "bce%d: Could not allocate TX descriptor chain DMA memory!"
328 The driver could not allocate DMA addressable memory for the controller's
330 .It "bce%d: Could not map TX descriptor chain DMA memory!"
331 The driver could not map the TX descriptor chain memory into the controller's DMA
334 The driver could not allocate a DMA tag for the controller's
335 TX mbuf memory.
337 The driver could not map the TX mbuf memory into the controller's DMA
340 The driver could not allocate a DMA tag for the controller's
343 The driver could not allocate DMA addressable memory for the controller's
345 .It "bce%d: Could not map RX descriptor chain DMA memory!"
346 The driver could not map the RX descriptor chain memory into the controller's DMA
349 The driver could not allocate a DMA tag for the controller's
350 RX mbuf memory.
352 The driver could not map the RX mbuf memory into the controller's DMA
356 controller.
371 The driver could not map a RX mbuf into DMA addressable memory.
376 the system, increase system memory, or if using jumbo frames, make sure
382 memory.
383 .It "bce%d: Controller reset failed!"
385 .It "bce%d: Controller initialization failed!"
390 The driver could not map a TX mbuf into DMA addressable memory.
397 tag stripping be enabled in the controller.
404 A controller hardware failure has occurred.
405 If the problem continues replace the controller.
411 or by E-mail at