Lines Matching +full:hardware +full:- +full:configured

1 .\"-
2 .\" Copyright (c) 2002-2009 Sam Leffler, Errno Consulting
39 .Bd -ragged -offset indent
49 .Bd -literal -offset indent
61 IBSS, MBSS, WDS/DWDS TDMA, and host-based access point operation modes.
70 AR5210-based devices support 802.11a operation with transmit speeds
72 AR5211-based devices support 802.11a and 802.11b operation with transmit
75 AR5212-based devices support 802.11a, 802.11b, and 802.11g operation
83 only interoperable with other Atheros-based devices.)
84 AR5212-based and AR5416-based devices also support half- (10MHz) and quarter-width (5MHz) channels.
89 AR5212, AR5416 and later parts have hardware support for the
90 AES-CCM, TKIP, and Michael cryptographic
99 .Cm adhoc-demo ,
108 virtual interfaces may be configured for simultaneous
110 When multiple interfaces are configured each may have a separate
115 virtual interfaces may be configured together with
133 driver come in Cardbus, ExpressCard, Mini-PCI and Mini-PCIe packages.
136 .Sh HARDWARE
143 .Bd -literal -offset indent
151 .Bd -literal -offset indent
157 Create an 802.11g host-based access point:
158 .Bd -literal -offset indent
165 .Bd -literal -offset indent
170 Create two virtual 802.11a host-based access points, one with
173 .Bd -literal -offset indent
175 	ssid paying-customers wepmode on wepkey 0x1234567890 \e
182 Create a master node in a two slot TDMA BSS configured to use
184 .Bd -literal -offset indent
186 	ssid tdma-test tmdaslot 0 tdmaslotlen 2500 \e
190 .Bl -diag
191 .It "ath%d: unable to attach hardware; HAL status %u"
192 The Atheros Hardware Access Layer was unable to configure the hardware
210 .It "ath%d: hardware error; resetting"
211 An unrecoverable error in the hardware occurred.
213 The driver will reset the hardware and continue.
215 The receive FIFO in the hardware overflowed before the data could be
217 This typically occurs because the hardware ran short of receive
219 The driver will reset the hardware and continue.
220 .It "ath%d: unable to reset hardware; hal status %u"
221 The Atheros Hardware Access Layer was unable to reset the hardware
230 A frame dispatched to the hardware for transmission did not complete in time.
231 The driver will reset the hardware and continue.
238 The Atheros Hardware Access Layer was unable to reset the hardware
242 The driver was unable to enable memory-mapped I/O to the PCI device registers.
276 Revision A1 of the D-LINK DWL-G520 and DWL-G650 are based on an
279 The driver does supports optional station mode power-save operation.
281 The AR5210 can only do WEP in hardware; consequently hardware assisted WEP
284 Hardware WEP can be re-enabled by modifying the driver.