Lines Matching full:dump

94 this.  The dump contains the contents of memory, but not
95 the swap areas.  Normally the dump device is a disk in
97 back of the partition.  The dump is placed in the back of the
98 partition because the primary swap and dump device are commonly
100 immediately overwriting the saved information.  When a dump has
103 the dump.  The \fIsavecore\fP\|(8)
104 program then copies the information from the dump partition to
107 ``/kernel'').  The offset to the system dump is defined in the
109 the front of the dump partition). The 
114 corresponding location in the dump area of the dump partition.
117 assumes a crash occurred and reads \fIdumpsize\fP from the dump area
118 of the dump partition.  This value is then used in copying the
119 system dump.  Refer to 
131 dump, \fIdumplo\fP is set to 0 (the start of the partition).