Lines Matching +full:pre +full:- +full:configurable

1 .\"-
2 .\" SPDX-License-Identifier: BSD-3-Clause
93 .Bl -tag -width indent
120 The format is specified as a comma-separated list of
141 .Bl -tag -width default
145 .Bl -tag -width default -compact
158 Adjust the display of link-level ethernet (MAC) addresses:
160 .Bl -tag -width default -compact
175 .Bl -tag -width default -compact
192 .Bl -tag -width default -compact
208 .Bl -tag -width default
350 The link-level
353 is specified as a series of colon-separated hex digits.
361 A randomly-generated MAC address might be the same as one already in use
366 up when the link-level address is modified,
378 .Bl -tag
419 Only the super-user may modify the configuration of a network interface.
425 .Bl -tag -width indent
438 for this interface, a non-conflicting netmask must be given.
462 and IEEE 802 48-bit MAC addresses (Ethernet addresses).
475 Enable the so-called sticky ARP mode for the interface.
480 high-performance Ethernet networks where the time needed for ARP resolution is
489 such as load-balancers or high-availabity solutions such as
492 Disable the so-called sticky ARP mode for the interface (default).
521 .It Cm -description , Cm -descr
545 .It Cm -group Ar groupname
558 The FIB is not inherited, e.g., vlans or other sub-interfaces will use
635 If the driver supports user-configurable checksum offloading,
650 If the driver supports user-configurable checksum offloading,
729 If the driver supports extended multi-page
733 If the driver supports extended multi-page
755 If the driver offers user-configurable VLAN support, enable
765 If the driver offers user-configurable VLAN support, disable
770 If the driver offers user-configurable VXLAN support, enable inner checksum
782 If the driver offers user-configurable VXLAN support, disable checksum
806 Create the specified network pseudo-device.
815 Destroy the specified network pseudo-device.
847 networks into sub-networks.
853 with a dot-notation Internet address,
854 or with a pseudo-network name listed in the network table
856 The mask contains 1's for the bit positions in the 32-bit address
871 bits are reserved for subdividing networks into sub-networks.
890 .It Cm link Op Cm 0 No - Cm 2
901 .It Fl link Op Cm 0 No - Cm 2
914 is an 3-bit field which refers to the IEEE 802.1p
925 the hardware will be re-initialized.
932 .Bl -tag -width indent
940 .It Cm -accept_rtadv
955 .It Cm -no_radr
959 Set a flag to perform automatic link-local address configuration when
966 .It Cm -auto_linklocal
972 .It Cm -defaultif
982 .It Cm -ifdisabled
987 flag is enabled, automatic configuration of a link-local address is
991 .It Cm -nud
998 policy table, configurable with
1000 .It Cm -no_prefer_iface
1005 .It Cm -no_dad
1014 .Bl -tag -width indent
1028 .It Cm -prefer_source
1039 .Bl -tag -width indent
1051 .Cm adhoc-demo ) ,
1067 .Cm adhoc-demo
1118 .Bl -tag -width indent
1133 This parameter controls the inter-packet gap for AMPDU frames.
1140 .Cm -
1246 ad-hoc or ap mode.
1271 .Cm -
1295 The set of channels is specified as a comma-separated list with
1298 .Dq Li a-b .
1309 .Dq Cm -
1318 with 802.11n and 802.11g then one can specify that g-only use
1334 .Bl -tag -compact
1361 .Bl -tag -compact
1363 5MHz aka quarter-rate channel
1365 10MHz aka half-rate channel
1391 Country/Region codes are specified as a 2-character abbreviation
1412 according to a least-congested criteria.
1504 another Dynamic Turbo-capable station.
1505 Dynamic Turbo mode is an Atheros-specific mechanism by which
1510 channel is free of non-dturbo stations; when a non-dturbo station
1522 DWDS is a facility by which 4-address traffic can be carried between
1526 Then 4-address frames are passed to carry traffic for stations
1531 When DWDS is enabled on an access point 4-address frames received from
1538 Once the WDS interface is up and running 4-address traffic then logically
1542 different from the peer station are encapsulated in a 4-address frame
1544 All 4-address traffic uses the security information of the stations
1547 4-address traffic using these same mechanisms; this depends on available
1553 another Fast Frames-capable station.
1558 Fast frame use is negotiated using the Atheros 802.11 vendor-specific
1560 non-Atheros devices.
1575 .Cm -
1584 To re-enable the broadcast of the SSID etc., use
1604 For example, if a station associates to an 11n-capable access point
1606 When an 11n-capable device is setup as an access point and
1614 Enable use of compatibility support for pre-802.11n devices (default).
1617 will not interoperate with a purely 11n-compliant station.
1706 .Ql -
1724 Display the access points and/or ad-hoc neighbors
1732 .Bl -tag -width 3n
1744 rather than an IBSS/ad-hoc network.
1747 Indicates that the station is part of an ad-hoc network
1753 such as WEP, TKIP, or AES-CCMP.
1788 (station supports unknown vendor-specific extensions).
1802 When operating in ad-hoc mode display stations identified as
1812 .Bl -tag -width 3n
1848 Wi-Fi Protected Setup (WPS).
1925 11g-capable stations to associate (11b-only stations are not
1927 To allow both 11g and 11b-only stations to associate, use
1931 HT-capable stations to associate (legacy stations are not
2028 .Cm -
2034 Only the super-user can initiate a scan.
2087 .Ql - .
2197 the mapping of text keys to WEP encryption is usually driver-specific.
2201 .Ql - .
2205 (1-4) will be the standard temporary keys and any others will be adaptor
2222 Parameters are specified per-AC (Access Category) and
2229 .Bl -tag -width ".Cm AC_BK" -compact
2248 AC parameters are case-insensitive.
2251 ToS (Type of Service) indication in IP-encapsulated frames.
2254 .Bl -tag -width indent
2267 On stations in a BSS this parameter is read-only and indicates
2274 On stations in a BSS this parameter is read-only and indicates
2279 On stations in a BSS this parameter is read-only and indicates
2284 On stations in a BSS this parameter is read-only and indicates
2291 On stations in a BSS this parameter is read-only and indicates
2308 Note that WPS support requires a WPS-capable supplicant.
2312 .Ss MAC-Based Access Control List Parameters
2320 .Bl -tag -width indent
2353 .Bl -tag -width indent
2408 This path may not be the best, but on-demand
2412 .Bl -tag -width ".Cm PROACTIVE" -compact
2440 .Bl -tag -width indent
2474 .Dq Li "wepmode on weptxkey 1 wepkey 1:key wepkey 2:- wepkey 3:- wepkey 4:-" .
2497 .Bl -tag -width indent
2524 .It Cm static Ar interface-name Ar address
2526 .Ar interface-name .
2527 Static entries are never aged out of the cache or re-placed, even if the
2534 Delete all dynamically-learned addresses from the address cache.
2548 .It Cm -discover Ar interface
2565 .It Cm -learn Ar interface
2577 .It Cm -sticky Ar interface
2587 .It Cm -private Ar interface
2598 .It Cm -span Ar interface
2609 .It Cm -stp Ar interface
2619 .It Cm -edge Ar interface
2627 .It Cm -autoedge Ar interface
2636 .It Cm -ptp Ar interface
2647 .It Cm -autoptp Ar interface
2702 .Bl -tag -width indent
2713 .It Cm -laggport Ar interface
2735 .Bl -tag -width ".Cm l2" -compact
2743 .It Cm -use_flowid
2752 .Cm -use_flowid
2783 .It Cm -use_numa
2788 Enable lacp fast-timeout on the interface.
2789 .It Cm -lacp_fast_timeout
2790 Disable lacp fast-timeout on the interface.
2804 .It Cm -lacp_strict
2807 Configure a stride for an interface in round-robin mode.
2813 .Bl -tag -width indent
2838 .It Cm -accept_rev_ethip_ver
2846 .It Cm -ignore_source
2856 .It Cm -send_rev_ethip_ver
2863 .Bl -tag -width indent
2891 .Bl -tag -width indent
2907 as point-to-point rather than using multicast to broadcast the messages.
2919 This is an 8-bit number; the default value is 128.
2936 .Bl -tag -width indent
2940 This value is a 12-bit VLAN Identifier (VID) which is used to create an 802.1Q
2953 .Bl -tag
2964 is an 3-bit field which refers to the IEEE 802.1p
3000 pseudo-interface.
3046 .Bl -tag -width indent
3048 This value is a 24-bit VXLAN Network Identifier (VNI) that identifies the
3056 The interface can be configured in a unicast, or point-to-point, mode
3108 Delete all dynamically-learned addresses from the forwarding table.
3116 .Bl -tag -width indent
3184 Valid values are 1-255.
3192 .Bl -tag -width IFCONFIG_FORMAT
3220 .Dl # ifconfig em0 inet 192.0.2.45 -alias
3223 .Dl # ifconfig em0 inet6 -ifdisabled
3236 .Dl # ifconfig em0 inet6 2001:db8:bdbd::123/48 -alias
3240 .Bd -literal -offset indent -compact
3248 .Dl # ifconfig xl0 media 100baseTX mediaopt full-duplex
3266 .Dl # ifconfig -f inet:cidr,inet6:cidr
3269 .Dl # ifconfig -a -u -G lo
3272 .Bd -literal -offset indent -compact
3273 # ifconfig -g wlan
3279 .Bd -literal -offset indent -compact
3280 # ifconfig -a -g wlan
3289         deftxkey UNDEF AES-CCM 2:128-bit AES-CCM 3:128-bit txpower 30 bmiss 10
3308 Set a randomly-generated MAC address on tap0:
3335 Basic IPv6 node operation requires a link-local address on each
3339 be disabled by setting per-interface flag
3340 .Cm -auto_linklocal .
3345 Do not configure IPv6 addresses with no link-local address by using