Lines Matching +full:only +full:- +full:1 +full:- +full:8 +full:v

7 .\" 1. Redistributions of source code must retain the above copyright
48 .Op Fl v
52 .Op Fl v
56 .Op Fl v
60 .Op Fl v
64 .Op Fl v
68 .Op Fl v
73 .Op Fl v
77 .Op Fl v
81 .Op Fl v
85 .Op Fl v
111 method uses on-disk metadata to detect device and all its paths.
121 .Bl -tag -width ".Cm destroy"
125 method without writing any on-disk metadata.
127 Kernel will only check that all given providers have same media and
139 Label the first given provider with on-disk metadata using the specified
161 Should normally be used only for devices created with
190 .Xr geom 8 .
193 .Xr geom 8 .
196 .Xr geom 8 .
199 .Xr geom 8 .
203 .Xr sysctl 8
207 .Bl -tag -width indent
212 This can be set to 0 (default) or 1 to disable or enable various
214 .It Va kern.geom.multipath.exclusive : No 1
218 Exit status is 0 on success, and 1 if the command fails.
248 In Active/Passive mode only one path has I/O moving on it
258 but unlike in Active/Active mode only one path handles write requests at any
269 on-disk metadata label, the device is either used to create a new
296 This means that this multipath architecture is not a one-shot path
305 .Xr camcontrol 8
309 .Xr camcontrol 8
313 .Bd -literal -offset indent
316 <ECNCTX @WESTVILLE >   at scbus0 target 0 lun 1 (da1,pass1)
318 <ECNCTX @WESTVILLE >   at scbus1 target 0 lun 1 (da3,pass3)
319 mysys# camcontrol inquiry da0 -S
321 mysys# camcontrol inquiry da2 -S
328 However, only the user who is familiar
337 .Bd -literal -offset indent
338 gmultipath label -v FRED /dev/da0 /dev/da2
339 disklabel -Bw /dev/multipath/FRED auto
345 .Bd -literal -offset indent
355 .Bd -literal -offset ident
363 .Xr camcontrol 8 ,
364 .Xr geom 8 ,
365 .Xr mount 8 ,
366 .Xr newfs 8 ,
367 .Xr sysctl 8