Lines Matching full:used
6 management GUI) is used to enable WPS enrollment and registrar
38 when WPS is used to configure the access point.
48 wpa_supplicant includes an optional WPS component that can be used as
69 The following parameter can be used to enable support for NFC config
102 The PIN value used in the commands must be processed by an UI to
104 digit. "wpa_cli wps_check_pin <PIN>" can be used to do such processing.
122 used. wpa_supplicant is notified this with a control interface
131 interface, an optional timeout parameter can be used to specify
137 can be used to generate a new PIN without starting WPS negotiation.
162 This is used to fetch the current AP settings instead of actually
183 flags field that is used to indicate whether the BSS support WPS. If
189 monitor events WPS-AP-AVAILABLE{,-PBC,-PIN} can be used to find out if
191 all the details in the GUI. These notification could be used, e.g., to
213 option. When this is used, an external program is responsible for
228 wpa_supplicant can be used as a WPS ER to configure an AP or enroll
234 operations. A special "none" driver can be used in such a case to
236 example, the following command could be used to start the ER:
249 - the optional IP address parameter can be used to filter operations only
263 only prepares a configuration to be used when enrolling a new device
279 - if Enrollee UUID is not known, "any" can be used to add a wildcard PIN
314 WPS can be used with NFC-based configuration method. An NFC tag
315 containing a password token from the Enrollee can be used to
317 with a configuration token can be used to transfer AP settings without
321 token can be used by touching the NFC interface of a Registrar.
328 (build with "make nfc_pw_token") can be used to generate NFC password
332 The "wps_nfc_config_token <WPS/NDEF>" command can be used to build an
339 can be used to touch an NFC interface on a station to provision the
342 The "wps_nfc_config_token <WPS/NDEF> <network id>" command can be used
356 then be used with wps_reg command (when the NFC password token was from
359 token is used to enable enrollment of a new station (that was the source
362 "nfc_get_handover_req <NDEF> <WPS-CR>" command can be used to build the
368 "nfc_get_handover_sel <NDEF> <WPS> [UUID|BSSID]" command can be used to
379 <carrier from handover select>" can be used as an alternative way for
386 used to build an NFC configuration token for the specified AP when
392 NFC configuration token can be used to touch an NFC interface on a