Lines Matching full:go

68 to be used for some operations (mainly WPS activation in GO). This may
145 is requesting an already running GO to prepare for a new client. This is
148 out whether the peer device is operating as a GO and if so, use
149 join-a-group style PD instead of GO Negotiation style PD.
170 group where this device was the GO. The previously used parameters will
171 then be used if the local end becomes the GO in GO Negotiation (which
175 client. It skips the GO Negotiation part. This will send a Provision
176 Discovery Request message to the target GO before associating for WPS
180 device without actually starting GO Negotiation (i.e., the peer is
181 expected to initiate GO Negotiation). This is mainly for testing
184 "go_intent" can be used to override the default GO Intent for this GO
191 used prior to starting GO Negotiation as a workaround with some deployed
196 out whether the peer device is operating as a GO and if so, use
197 join-a-group operation rather than GO Negotiation.
269 GO. Optional persistent=<network id> can be used to specify restart of
271 the GO to be started on a specific frequency. Special freq=2 or freq=5
278 address). This is a mechanism to reject a pending GO Negotiation with
301 (operating and persistent) from the local GO. Note that the peer device
326 	4 == auto-accept GO role)
565 persistent group (e.g., persistent=4). If the peer device is the GO of
568 used to override the GO device address for Invitation Request should
570 cases). When reinvoking a persistent group, the GO device can specify
573 a specific operating channel (or invitation failure if GO rejects that)
574 or pref parameter to request a specific channel (while allowing GO to
584 the AP/GO. This is used on the GO when a P2P client joins an existing
593 Enrollee to connect to the AP/GO. This is used on the GO when a P2P
598 Get the passphrase for a group (only available when acting as a GO).
602 Send a P2P Presence Request to the GO (this is only available when
604 request indicates that this client has no special needs for GO
608 immediately and the response from the GO is indicated in a
663 can be used to request GO to assign a unique PSK for each client during
670 passphrase on the GO that is normally used to allow legacy stations to
722 set p2p_go_intent <GO intent>
724 Set the default P2P GO Intent. Note: This value can be overridden in
773 Show information about an associated station (when acting in AP/GO role).
816 …conncap=1 session=1234567 session_mac=00:11:22:33:44:55 [dev_passwd_id=8 | go=p2p-wlan0-0 | join=1…
827     dev_passwd_id - only if conncap value == 1 (New GO negotiation)
833     go only - if conncap value == 4 (GO Only). Interface name must be set with a