Lines Matching +full:3 +full:br
19 <p>Address: 127.127.27.<i>u</i><br>
20 Reference ID: <tt>MSFa</tt> / <tt>MSF</tt> / <tt>DCF</tt> / <tt>WWVB</tt><br>
21 Driver ID: <tt>MSF_ARCRON</tt><br>
22 Serial Port: <tt>/dev/arc<i>u</i></tt>; 300 baud, 8-bits, 2-stop, no parity<br>
26 …<p>This documentation describes v1.3 (2003/2/21) of the source and has been tested against ntpd 4.…
28 …had been tested (amongst others) against ntpd3-5.90 on Solaris-1 (SunOS 4.1.3_U1 on an SS1 serving…
34 … it is in effect. The driver code converts the time back to UTC. In modes 1-3 the driver can be co…
41 …<p>When alternate modes 1-3 are selected, the driver can be configured to ignore the resync reques…
61 <dt>bit 3
79 <dt>bit 3
82 …ected. The reported value drops to zero when not resyncing, ie when first returned byte is not `3'.
112 <dt>bit 3
113 <dd>(MSF) always 0<br>
114 (WWVB) Leap year indicator bit<br>
115 0 = non-leap year<br>
118 <dd>= (MSF) 1 if UTC is in effect (reverse of bit 1)<br>
121 <dd>= (MSF)1 if BST is in effect (reverse of bit 2)<br>
124 <dd>= (MSF)1 if BST/UTC change pending<br>
137 <dt>bit 3
142 <dd>= 1 if at least one reception attempt was successful<br>
143 (MSF) since 0230<br>
144 (DCF) since 0300<br>
165 server 127.127.27.0 mode 3 # ARCRON WWVB radio clock
169 peer 11.22.33.4 # tock(3), boot/NFS server.
213 May 10 12:41:34 oolong ntpd[615]: ARCRON: sync finished, signal quality 3: OK, will use clock</pre>
217 <dt><tt>mode 0 | 1 | 2 | 3</tt>
223 <dd>3 - New WWVB
225 …s and fraction, with default 0.0. On a Sun SparcStation 1 running SunOS 4.1.3_U1, with the receive…
231 …om one to four characters, with default <tt>MSFa</tt>. When used in modes 1-3, the driver will rep…
233 …<dd>(Modes 1-3) If set to 0 (the default), the clock is set to UTC time. If set to 1, the clock is…
235 …<dd>(Modes 1-3) If set to 0 (the default), the clock will be forced to resync approximately every …
242 <p><a href="../refclock.html">Reference Clock Drivers</a><br>