Lines Matching +full:em +full:- +full:uart
1 <!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
4 <meta http-equiv="content-type" content="text/html;charset=iso-8859-1">
13 <!-- #BeginDate format:En2m -->26-Sep-2019 06:34<!-- #EndDate -->
22 <p>Unless noted otherwise, further information about these ccommands is on the <a href="refclock.html">Reference Clock Support</a> page.</p><p>Reference clocks are identified by a syntactically correct but invalid IP address, in order to distinguish them from ordinary NTP peers. These addresses are of the form 127.127.<em>t</em>.<em>u</em>, where <em>t</em> is an integer denoting the clock type and <em>u</em> indicates the unit number in the range 0-3. While it may seem overkill, it is in fact sometimes useful to configure multiple reference clocks of the same type, in which case the unit numbers must be unique.</p>
31 <dd>Specifies a mode number which is interpreted in a device-specific fashion. For instance, it selects a dialing protocol in the ACTS driver and a device subtype in the <tt>parse</tt> drivers.</dd>
43 <dd>Specifies a constant to be added to the time offset produced by the driver, a fixed-point decimal number in seconds. This is used as a calibration constant to adjust the nominal time offset of a particular clock to agree with an external standard, such as a precision PPS signal. It also provides a way to correct a systematic error or bias due to serial port or operating system latencies, different cable lengths or receiver internal delay. The specified offset is in addition to the propagation delay provided by other means, such as internal DIPswitches. Where a calibration for an individual system and driver is available, an approximate correction is noted in the driver documentation pages.</dd>
46 <dd>Specifies a fixed-point decimal number in seconds, which is interpreted in a driver-dependent way. See the descriptions of specific drivers in the <a href="refclock.html">Reference Clock Support</a> page.</dd>
77 clocks should use. Every clock has a special hard-coded builtin
94 POSIX-like system or "<tt>\\.\COM4</tt>" for another widely used OS.
105 the UART that handles the serial data; instead it might