Lines Matching +full:codec +full:- +full:driver
1 <!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
4 <meta http-equiv="content-type" content="text/html;charset=iso-8859-1">
11 <img src="pic/radio2.jpg" alt="jpg" align="left">ICOM R-72 shortwave receiver and Sure audio mixer
13 <!-- #BeginDate format:En2m -->11-Sep-2010 05:55<!-- #EndDate -->
27 …rd audio codec. The suite of NTP reference clock drivers currently includes three drivers suitable…
31 and decoding techniques, including maximum-likelihood and soft-decision methods.
32 The documentation page for each driver contains an in-depth discussion on
37 …codec sample clock to the audio signal as received. This is done by stuffing or slipping samples a…
38 …e flag 2</tt> command selects the microphone port if set to zero or the line-in port if set to one…
40 …l shortwave radio with the radio output - speaker or headphone jack - connected to either the micr…
41 …- even 15 feet is enough if it is located outside of a metal frame building, preferably on the roo…
42 … house wiring, which can also be used to power the radio. A couple of center-tapped audio transfor…
43 …our. While both drivers support the ICOM CI-V radio interface and can tune the radio automatically…
44 <p>Shortwave (3-30 MHz) radio propagation phenomena are well known to shortwave enthusiasts. The ph…
52 …<li>The optimum frequencies are higher at the peak of the 11-year sunspot cycle and lower at the t…
56 …ment disables the CI-V interface. Since all ICOM select codes are less than 128, the high order bi…
156 … help hook up the audio signals and monitor the driver operations. The documentation page for each…
160 radios have recorder outputs which produce a microphone-level signal not affected
163 headphone or speaker output to the line-in port and adjust the volume control
164 so the driver indicates comfortably above the minimum specified and the AGC
165 level somewhere in the middle of the range 0-255. IRIG signals are usually
167 may even overload the line-in port. In such cases the signal is designed to
168 drive a cable terminated with a 50-ohm resistor, which results in a level
169 the line-in port can handle..</p>
170 <p>It is very easy to underdriven or overdrive the audio codec, in which case
174 codec and generally free of noise and interference. Note that the monitor
175 volume must be set before the driver is started.</p>
176 …-length fields defining the UTC time to the millisecond, together with additional variable-length …