Lines Matching +full:data +full:- +full:width
14 .\" WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN
47 .Sx Data
51 All input must be 7-bit ASCII.
54 case-insensitive options separated by spaces, tabs, or commas.
61 .Bl -tag -width Ds
63 Draw a single-line box around each table cell.
65 Draw a single-line box around the table.
69 Center the table instead of left-adjusting it.
73 Use the single-character argument as the decimal point with the
83 Draw a double-line box around the table.
87 Increase the width of the table to the current line length.
96 Ignore leading and trailing spaces in data cells.
102 Use the single-character argument as a delimiter between data cells.
115 .Sx Data
118 It also applies to all remaining data lines.
124 The following case-insensitive key characters start a new cell
126 .Bl -tag -width 2n
130 Right-justify the string in this cell.
132 Left-justify the string in this cell.
139 .Pf non- Cm s
147 of the corresponding data line.
149 Left-justify a string and pad with one space.
152 .Pf non- Cm \(ha
155 Unlike a horizontal span, a vertical span consumes a data cell
159 This consumes a data cell and discards the content.
161 .Cm \- .
164 This consumes a data cell and discards the content.
168 case-insensitive modifiers:
169 .Bl -tag -width 2n
176 Make this column wider to match the maximum width
182 One-character font names must be followed by a blank or period.
207 Specify a minimum column width.
209 After determining the width of all other columns, distribute the
214 Do not use this cell for determining the width of this column.
227 .Ss Data
228 The data section follows the last
231 Each data line consists of one or more data cells, delimited by
235 If a data cell contains only the two bytes
241 If a data cell contains only the single character
247 If a data cell contains only the two character sequence
253 If a data line contains nothing but the single character
260 In place of any data cell, a text block can be used.
265 neither end the text block nor its data cell.
269 by an end-of-cell indicator.
273 the data cell, and the data line ends at this point.
278 character, only the text block and the data cell end,
279 but the data line continues with the data cell following the
288 .Bd -literal -offset indent
297 .Bd -filled -offset indent
310 .Bd -literal -offset indent
323 .Bd -filled -offset indent
337 Spans and skipping width calculations:
338 .Bd -literal -offset indent
349 .Bd -filled -offset indent
364 .Bd -literal -offset indent
371 the column width.:T{
372 This text is too wide to fit into a column of width 17.
379 .Bd -filled -offset indent
386 the column width.:T{
387 This text is too wide to fit into a column of width 17.