man/man7d/sfe.7d

         te
 Copyright (c) 2007 by Sun Microsystems, Inc. All Rights Reserved.
 The contents of this file are subject to the terms of the Common Development and Distribution License (the "License"). You may not use this file except in compliance with the License.
 You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE or http://www.opensolaris.org/os/licensing. See the License for the specific language governing permissions and limitations under the License.
 When distributing Covered Code, include this CDDL HEADER in each file and include the License file at usr/src/OPENSOLARIS.LICENSE. If applicable, add the following below this CDDL HEADER, with the fields enclosed by brackets "[]" replaced with your own identifying information: Portions Copyright [yyyy] [name of copyright owner]
 SFE 7D "Dec 12, 2007"
 NAME
sfe - SiS900 series Fast Ethernet device driver
 SYNOPSIS

/dev/sfe


 DESCRIPTION

The sfe driver is a loadable, clonable, GLD-based STREAMS driver
supporting the Data Link Provider Interface dlpi(7P) on Silicon
Integrated Systems 900 series Fast Ethernet controllers.
 APPLICATION PROGRAMMING INTERFACE

The relevant fields returned as part of a DL_INFO_ACK response are:


Maximum SDU is 1500.


Minimum SDU is 0.


The dlsap address length is 8.


MAC type is DL_ETHER.


SAP length is -2. The 6-byte physical address is followed immediately by a
2-byte SAP.


Service mode is DL_CLDLS.


Broadcast address is the 6-byte Ethernet broadcast address
(ff:ff:ff:ff:ff:ff).


If the SAP provided is zero, then IEEE 802.3 mode is assumed and outbound
frames will have the frame payload length written into the type field.
Likewise, inbound frames with a SAP between zero and 1500 are interpreted as
IEEE 802.3 frames and delivered to any streams that are bound to SAP zero
(the 802.3 SAP).
 PROPERTIES

The following properties may be configured using either ndd(1M) or
the sfe.conf configuration file as described by driver.conf(4):
adv_100fdx_cap

Enables the 100 Base TX full-duplex link option. (This is generally the fastest
mode if both link partners support it. Most modern equipment supports this
mode.)


adv_100hdx_cap

Enables the 100 Base TX half-duplex link option. (Typically used when the link
partner is a 100 Mbps hub.)


adv_10fdx_cap

Enables the 10 Base-T full-duplex link option. (This less-frequently used mode
is typically used when the link partner is a 10 Mbps switch.)


adv_10hdx_cap

Enables the 10 Base-T half-duplex link option. (This is the fall-back when no
other option is available. It is typically used when the link partner is a 10
Mbps hub or is an older network card.)


 ATTRIBUTES

See attributes(5) for a description of the following attributes:


ATTRIBUTE TYPE ATTRIBUTE VALUE
Interface Stability Committed


 FILES
/dev/sfe

Special character device.


/kernel/drv/sfe

32-bit driver binary (x86).


/kernel/drv/amd64/sfe

64-bit driver binary (x86).


/kernel/drv/sparcv9/sfe

64-bit driver binary (SPARC).


/kernel/drv/sfe.conf

Configuration file.


 SEE ALSO

ndd(1M), driver.conf(4), attributes(5), streamio(7I),
dlpi(7P)

IEEE 802.3 \(em Institute of Electrical and Electronics Engineers, 2002