xref: /linux/drivers/net/wireless/realtek/rtw88/rtw8703b.h (revision f73a058be5d70dd81a43f16b2bbff4b1576a7af8)
1 /* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */
2 /* Copyright Fiona Klute <fiona.klute@gmx.de> */
3 
4 #ifndef __RTW8703B_H__
5 #define __RTW8703B_H__
6 
7 #include "rtw8723x.h"
8 
9 extern const struct rtw_chip_info rtw8703b_hw_spec;
10 
11 /* phy status parsing */
12 #define VGA_BITS GENMASK(4, 0)
13 #define LNA_L_BITS GENMASK(7, 5)
14 #define LNA_H_BIT BIT(7)
15 /* masks for assembling LNA index from high and low bits */
16 #define BIT_LNA_H_MASK BIT(3)
17 #define BIT_LNA_L_MASK GENMASK(2, 0)
18 
19 struct phy_rx_agc_info {
20 #ifdef __LITTLE_ENDIAN
21 	u8 gain: 7;
22 	u8 trsw: 1;
23 #else
24 	u8 trsw: 1;
25 	u8 gain: 7;
26 #endif
27 } __packed;
28 
29 /* This struct is called phy_status_rpt_8192cd in the vendor driver,
30  * there might be potential to share it with drivers for other chips
31  * of the same generation.
32  */
33 struct phy_status_8703b {
34 	struct phy_rx_agc_info path_agc[2];
35 	u8 ch_corr[2];
36 	u8 cck_sig_qual_ofdm_pwdb_all;
37 	/* for CCK: bits 0:4: VGA index, bits 5:7: LNA index (low) */
38 	u8 cck_agc_rpt_ofdm_cfosho_a;
39 	/* for CCK: bit 7 is high bit of LNA index if long report type */
40 	u8 cck_rpt_b_ofdm_cfosho_b;
41 	u8 reserved_1;
42 	u8 noise_power_db_msb;
43 	s8 path_cfotail[2];
44 	u8 pcts_mask[2];
45 	s8 stream_rxevm[2];
46 	u8 path_rxsnr[2];
47 	u8 noise_power_db_lsb;
48 	u8 reserved_2[3];
49 	u8 stream_csi[2];
50 	u8 stream_target_csi[2];
51 	s8 sig_evm;
52 	u8 reserved_3;
53 
54 #ifdef __LITTLE_ENDIAN
55 	u8 antsel_rx_keep_2: 1;
56 	u8 sgi_en: 1;
57 	u8 rxsc: 2;
58 	u8 idle_long: 1;
59 	u8 r_ant_train_en: 1;
60 	u8 ant_sel_b: 1;
61 	u8 ant_sel: 1;
62 #else /* __BIG_ENDIAN */
63 	u8 ant_sel: 1;
64 	u8 ant_sel_b: 1;
65 	u8 r_ant_train_en: 1;
66 	u8 idle_long: 1;
67 	u8 rxsc: 2;
68 	u8 sgi_en: 1;
69 	u8 antsel_rx_keep_2: 1;
70 #endif
71 } __packed;
72 
73 /* Baseband registers */
74 #define REG_BB_PWR_SAV5_11N 0x0818
75 /* BIT(11) should be 1 for 8703B *and* 8723D, which means LNA uses 4
76  * bit for CCK rates in report, not 3. Vendor driver logs a warning if
77  * it's 0, but handles the case.
78  *
79  * Purpose of other parts of this register is unknown, 8723cs driver
80  * code indicates some other chips use certain bits for antenna
81  * diversity.
82  */
83 #define REG_BB_AMP 0x0950
84 #define BIT_MASK_RX_LNA (BIT(11))
85 
86 /* 0xaXX: 40MHz channel settings */
87 #define REG_CCK_TXSF2 0x0a24  /* CCK TX filter 2 */
88 #define REG_CCK_DBG 0x0a28  /* debug port */
89 #define REG_OFDM0_A_TX_AFE 0x0c84
90 #define REG_TXIQK_MATRIXB_LSB2_11N 0x0c9c
91 #define REG_OFDM0_TX_PSD_NOISE 0x0ce4  /* TX pseudo noise weighting */
92 #define REG_IQK_RDY 0x0e90  /* is != 0 when IQK is done */
93 
94 /* RF registers */
95 #define RF_RCK1 0x1E
96 
97 #define AGG_BURST_NUM 3
98 #define AGG_BURST_SIZE 0 /* 1K */
99 #define BIT_MASK_AGG_BURST_NUM (GENMASK(3, 2))
100 #define BIT_MASK_AGG_BURST_SIZE (GENMASK(5, 4))
101 
102 #endif /* __RTW8703B_H__ */
103