1.\" Copyright (c) 1985, 1986, 1988, 1994 2.\" The Regents of the University of California. All rights reserved. 3.\" 4.\" Redistribution and use in source and binary forms, with or without 5.\" modification, are permitted provided that the following conditions 6.\" are met: 7.\" 1. Redistributions of source code must retain the above copyright 8.\" notice, this list of conditions and the following disclaimer. 9.\" 2. Redistributions in binary form must reproduce the above copyright 10.\" notice, this list of conditions and the following disclaimer in the 11.\" documentation and/or other materials provided with the distribution. 12.\" 4. Neither the name of the University nor the names of its contributors 13.\" may be used to endorse or promote products derived from this software 14.\" without specific prior written permission. 15.\" 16.\" THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND 17.\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE 18.\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE 19.\" ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE 20.\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL 21.\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS 22.\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) 23.\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT 24.\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY 25.\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF 26.\" SUCH DAMAGE. 27.\" 28.\" @(#)arp4.4 6.5 (Berkeley) 4/18/94 29.\" $FreeBSD$ 30.\" 31.Dd September 3, 2012 32.Dt ARP 4 33.Os 34.Sh NAME 35.Nm arp 36.Nd Address Resolution Protocol 37.Sh SYNOPSIS 38.Cd "device ether" 39.Sh DESCRIPTION 40The Address Resolution Protocol (ARP) is used to dynamically 41map between Protocol Addresses (such as IP addresses) and 42Local Network Addresses (such as Ethernet addresses). 43This implementation maps IP addresses to Ethernet, 44ARCnet, 45or Token Ring addresses. 46It is used by all the Ethernet interface drivers. 47.Pp 48ARP caches Internet-Ethernet address mappings. 49When an interface requests a mapping for an address not in the cache, 50ARP queues the message which requires the mapping and broadcasts 51a message on the associated network requesting the address mapping. 52If a response is provided, the new mapping is cached and any pending 53message is transmitted. 54ARP will queue at most one packet while waiting for a response to a 55mapping request; 56only the most recently ``transmitted'' packet is kept. 57If the target host does not respond after several requests, 58the host is considered to be down allowing an error to be returned to 59transmission attempts. 60Further demand for this mapping causes ARP request retransmissions, that 61are ratelimited to one packet per second. 62The error is 63.Er EHOSTDOWN 64for a non-responding destination host, and 65.Er EHOSTUNREACH 66for a non-responding router. 67.Pp 68The ARP cache is stored in the system routing table as 69dynamically-created host routes. 70The route to a directly-attached Ethernet network is installed as a 71.Dq cloning 72route (one with the 73.Li RTF_CLONING 74flag set), 75causing routes to individual hosts on that network to be created on 76demand. 77These routes time out periodically (normally 20 minutes after validated; 78entries are not validated when not in use). 79.Pp 80ARP entries may be added, deleted or changed with the 81.Xr arp 8 82utility. 83Manually-added entries may be temporary or permanent, 84and may be 85.Dq published , 86in which case the system will respond to ARP requests for that host 87as if it were the target of the request. 88.Pp 89In the past, 90ARP was used to negotiate the use of a trailer encapsulation. 91This is no longer supported. 92.Pp 93ARP watches passively for hosts impersonating the local host (i.e., a host 94which responds to an ARP mapping request for the local host's address). 95.Pp 96Proxy ARP is a feature whereby the local host will respond to requests 97for addresses other than itself, with its own address. 98Normally, proxy ARP in 99.Fx 100is set up on a host-by-host basis using the 101.Xr arp 8 102utility, by adding an entry for each host inside a given subnet for 103which proxying of ARP requests is desired. 104However, the 105.Dq "proxy all" 106feature causes the local host to act as a proxy for 107.Em all 108hosts reachable through some other network interface, 109different from the one the request came in from. 110It may be enabled by setting the 111.Xr sysctl 8 112MIB variable 113.Va net.link.ether.inet.proxyall 114to 1. 115.Sh MIB Variables 116The ARP protocol implements a number of configurable variables in 117.Va net.link.ether.inet 118branch 119of the 120.Xr sysctl 3 121MIB. 122.Bl -tag -width "log_arp_permanent_modify" 123.It Va allow_multicast 124Should the kernel install ARP entries with multicast bit set in 125the hardware address. 126Installing such entries is RFC 1812 violation, but some prorietary 127load balancing techniques require routers on network to do so. 128Turned off by default. 129.It Va log_arp_movements 130Should the kernel log movements of IP addresses from one hardware 131address to an other. 132See 133.Sx DIAGNOSTICS 134below. 135Turned on by default. 136.It Va log_arp_permanent_modify 137Should the kernel log attempts of remote host on network to modify a 138permanent ARP entry. 139See 140.Sx DIAGNOSTICS 141below. 142Turned on by default. 143.It Va log_arp_wrong_iface 144Should the kernel log attempts to insert an ARP entry on an interface 145when the IP network the address belongs to is connected to an other 146interface. 147See 148.Sx DIAGNOSTICS 149below. 150Turned on by default. 151.It Va max_age 152How long an ARP entry is held in the cache until it needs to be refreshed. 153Default is 1200 seconds. 154.It Va maxhold 155How many packets hold in the per-entry output queue while the entry 156is being resolved. 157Default is one packet. 158.It Va maxtries 159Number of retransmits before host is considered down and error is returned. 160Default is 5 tries. 161.It Va proxyall 162Enables ARP proxying for all hosts on net. 163Turned off by default. 164.It Va useloopback 165If an ARP entry is added for local address, force the traffic to go through 166the loopback interface. 167Turned on by default. 168.It Va wait 169Lifetime of an incomplete ARP entry. 170Default is 20 seconds. 171.El 172.Sh DIAGNOSTICS 173.Bl -diag 174.It "arp: %x:%x:%x:%x:%x:%x is using my IP address %d.%d.%d.%d on %s!" 175ARP has discovered another host on the local network which responds to 176mapping requests for its own Internet address with a different Ethernet 177address, generally indicating that two hosts are attempting to use the 178same Internet address. 179.It "arp: link address is broadcast for IP address %d.%d.%d.%d!" 180ARP requested information for a host, and received an answer indicating 181that the host's ethernet address is the ethernet broadcast address. 182This indicates a misconfigured or broken device. 183.It "arp: %d.%d.%d.%d moved from %x:%x:%x:%x:%x:%x to %x:%x:%x:%x:%x:%x on %s" 184ARP had a cached value for the ethernet address of the referenced host, 185but received a reply indicating that the host is at a new address. 186This can happen normally when host hardware addresses change, 187or when a mobile node arrives or leaves the local subnet. 188It can also indicate a problem with proxy ARP. 189This message can only be issued if the sysctl 190.Va net.link.ether.inet.log_arp_movements 191is set to 1, which is the system's default behaviour. 192.It "arpresolve: can't allocate llinfo for %d.%d.%d.%d" 193The route for the referenced host points to a device upon which ARP is 194required, but ARP was unable to allocate a routing table entry in which 195to store the host's MAC address. 196This usually points to a misconfigured routing table. 197It can also occur if the kernel cannot allocate memory. 198.It "arp: %d.%d.%d.%d is on if0 but got reply from %x:%x:%x:%x:%x:%x on if1" 199Physical connections exist to the same logical IP network on both if0 and if1. 200It can also occur if an entry already exists in the ARP cache for the IP 201address above, and the cable has been disconnected from if0, then reconnected 202to if1. 203This message can only be issued if the sysctl 204.Va net.link.ether.inet.log_arp_wrong_iface 205is set to 1, which is the system's default behaviour. 206.It "arp: %x:%x:%x:%x:%x:%x attempts to modify permanent entry for %d.%d.%d.%d on %s" 207ARP has received an ARP reply that attempts to overwrite a permanent 208entry in the local ARP table. 209This error will only be logged if the sysctl 210.Va net.link.ether.inet.log_arp_permanent_modify 211is set to 1, which is the system's default behaviour. 212.It "arp: %x:%x:%x:%x:%x:%x is multicast" 213Kernel refused to install an entry with multicast hardware address. 214If you really want such addresses being installed, set the sysctl 215.Va net.link.ether.inet.allow_multicast 216to a positive value. 217.El 218.Sh SEE ALSO 219.Xr inet 4 , 220.Xr route 4 , 221.Xr arp 8 , 222.Xr ifconfig 8 , 223.Xr route 8 , 224.Xr sysctl 8 225.Rs 226.%A Plummer, D. 227.%B "An Ethernet Address Resolution Protocol" 228.%T RFC826 229.Re 230.Rs 231.%A Leffler, S.J. 232.%A Karels, M.J. 233.%B "Trailer Encapsulations" 234.%T RFC893 235.Re 236