xref: /freebsd/sbin/fsck_ffs/fsck_ffs.8 (revision 2be1a816b9ff69588e55be0a84cbe2a31efc0f2f)
1.\"
2.\" Copyright (c) 1980, 1989, 1991, 1993
3.\"	The Regents of the University of California.  All rights reserved.
4.\"
5.\" Redistribution and use in source and binary forms, with or without
6.\" modification, are permitted provided that the following conditions
7.\" are met:
8.\" 1. Redistributions of source code must retain the above copyright
9.\"    notice, this list of conditions and the following disclaimer.
10.\" 2. Redistributions in binary form must reproduce the above copyright
11.\"    notice, this list of conditions and the following disclaimer in the
12.\"    documentation and/or other materials provided with the distribution.
13.\" 4. Neither the name of the University nor the names of its contributors
14.\"    may be used to endorse or promote products derived from this software
15.\"    without specific prior written permission.
16.\"
17.\" THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND
18.\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
19.\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
20.\" ARE DISCLAIMED.  IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE
21.\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
22.\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
23.\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
24.\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
25.\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
26.\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
27.\" SUCH DAMAGE.
28.\"
29.\"	@(#)fsck.8	8.4 (Berkeley) 5/9/95
30.\" $FreeBSD$
31.\"
32.Dd April 10, 2008
33.Dt FSCK_FFS 8
34.Os
35.Sh NAME
36.Nm fsck_ffs ,
37.Nm fsck_ufs
38.Nd file system consistency check and interactive repair
39.Sh SYNOPSIS
40.Nm
41.Op Fl BCFpfny
42.Op Fl b Ar block
43.Op Fl c Ar level
44.Op Fl m Ar mode
45.Ar filesystem
46.Ar ...
47.Sh DESCRIPTION
48The specified disk partitions and/or file systems are checked.
49In "preen" mode the clean flag of each file system's superblock is examined
50and only those file systems that
51are not marked clean are checked.
52File systems are marked clean when they are unmounted,
53when they have been mounted read-only, or when
54.Nm
55runs on them successfully.
56If the
57.Fl f
58option is specified, the file systems
59will be checked regardless of the state of their clean flag.
60.Pp
61The kernel takes care that only a restricted class of innocuous file system
62inconsistencies can happen unless hardware or software failures intervene.
63These are limited to the following:
64.Pp
65.Bl -item -compact -offset indent
66.It
67Unreferenced inodes
68.It
69Link counts in inodes too large
70.It
71Missing blocks in the free map
72.It
73Blocks in the free map also in files
74.It
75Counts in the super-block wrong
76.El
77.Pp
78These are the only inconsistencies that
79.Nm
80with the
81.Fl p
82option will correct; if it encounters other inconsistencies, it exits
83with an abnormal return status and an automatic reboot will then fail.
84For each corrected inconsistency one or more lines will be printed
85identifying the file system on which the correction will take place,
86and the nature of the correction.
87After successfully correcting a file system,
88.Nm
89will print the number of files on that file system,
90the number of used and free blocks,
91and the percentage of fragmentation.
92.Pp
93If sent a
94.Dv QUIT
95signal,
96.Nm
97will finish the file system checks, then exit with an abnormal
98return status that causes an automatic reboot to fail.
99This is useful when you want to finish the file system checks during an
100automatic reboot,
101but do not want the machine to come up multiuser after the checks complete.
102.Pp
103If
104.Nm
105receives a
106.Dv SIGINFO
107(see the
108.Dq status
109argument for
110.Xr stty 1 )
111signal, a line will be written to the standard output indicating
112the name of the device currently being checked, the current phase
113number and phase-specific progress information.
114.Pp
115Without the
116.Fl p
117option,
118.Nm
119audits and interactively repairs inconsistent conditions for file systems.
120If the file system is inconsistent the operator is prompted for concurrence
121before each correction is attempted.
122It should be noted that some of the corrective actions which are not
123correctable under the
124.Fl p
125option will result in some loss of data.
126The amount and severity of data lost may be determined from the diagnostic
127output.
128The default action for each consistency correction
129is to wait for the operator to respond
130.Li yes
131or
132.Li no .
133If the operator does not have write permission on the file system
134.Nm
135will default to a
136.Fl n
137action.
138.Pp
139The following flags are interpreted by
140.Nm :
141.Bl -tag -width indent
142.It Fl F
143Determine whether the file system needs to be cleaned immediately
144in foreground, or if its cleaning can be deferred to background.
145To be eligible for background cleaning it must have been running
146with soft updates, not have been marked as needing a foreground check,
147and be mounted and writable when the background check is to be done.
148If these conditions are met, then
149.Nm
150exits with a zero exit status.
151Otherwise it exits with a non-zero exit status.
152If the file system is clean,
153it will exit with a non-zero exit status so that the clean status
154of the file system can be verified and reported during the foreground
155checks.
156Note that when invoked with the
157.Fl F
158flag, no cleanups are done.
159The only thing that
160.Nm
161does is to determine whether a foreground or background
162check is needed and exit with an appropriate status code.
163.It Fl B
164A check is done on the specified and possibly active file system.
165The set of corrections that can be done is limited to those done
166when running in preen mode (see the
167.Fl p
168flag).
169If unexpected errors are found,
170the file system is marked as needing a foreground check and
171.Nm
172exits without attempting any further cleaning.
173.It Fl b
174Use the block specified immediately after the flag as
175the super block for the file system.
176An alternate super block is usually located at block 32 for UFS1,
177and block 160 for UFS2.
178.It Fl C
179Run
180.Nm
181in 'catastrophic recovery' mode, which will enable certain aggressive
182operations that can make
183.Nm
184to survive with file systems that has very serious data damage, which
185is an useful last resort when on disk data damage is very serious
186and causes
187.Nm
188to crash otherwise.  Be
189.Em very careful
190using this flag, is dangerous if there are data transmission hazards
191because a false positive cylinder group magic number mismatch could
192cause
193.Em irrevertible data loss!
194.Pp
195This option implies the
196.Fl f
197flag.
198.It Fl c
199Convert the file system to the specified level.
200Note that the level of a file system can only be raised.
201There are currently four levels defined:
202.Bl -tag -width indent
203.It 0
204The file system is in the old (static table) format.
205.It 1
206The file system is in the new (dynamic table) format.
207.It 2
208The file system supports 32-bit uid's and gid's,
209short symbolic links are stored in the inode,
210and directories have an added field showing the file type.
211.It 3
212If maxcontig is greater than one,
213build the free segment maps to aid in finding contiguous sets of blocks.
214If maxcontig is equal to one, delete any existing segment maps.
215.El
216.Pp
217In interactive mode,
218.Nm
219will list the conversion to be made
220and ask whether the conversion should be done.
221If a negative answer is given,
222no further operations are done on the file system.
223In preen mode,
224the conversion is listed and done if
225possible without user interaction.
226Conversion in preen mode is best used when all the file systems
227are being converted at once.
228The format of a file system can be determined from the
229first line of output from
230.Xr dumpfs 8 .
231.It Fl f
232Force
233.Nm
234to check
235.Sq clean
236file systems when preening.
237.It Fl m
238Use the mode specified in octal immediately after the flag as the
239permission bits to use when creating the
240.Pa lost+found
241directory rather than the default 1777.
242In particular, systems that do not wish to have lost files accessible
243by all users on the system should use a more restrictive
244set of permissions such as 700.
245.It Fl n
246Assume a no response to all questions asked by
247.Nm
248except for
249.Ql CONTINUE? ,
250which is assumed to be affirmative;
251do not open the file system for writing.
252.It Fl p
253Preen file systems (see above).
254.It Fl y
255Assume a yes response to all questions asked by
256.Nm ;
257this should be used with great caution as this is a free license
258to continue after essentially unlimited trouble has been encountered.
259.El
260.Pp
261Inconsistencies checked are as follows:
262.Pp
263.Bl -enum -compact
264.It
265Blocks claimed by more than one inode or the free map.
266.It
267Blocks claimed by an inode outside the range of the file system.
268.It
269Incorrect link counts.
270.It
271Size checks:
272.Bl -item -offset indent -compact
273.It
274Directory size not a multiple of DIRBLKSIZ.
275.It
276Partially truncated file.
277.El
278.It
279Bad inode format.
280.It
281Blocks not accounted for anywhere.
282.It
283Directory checks:
284.Bl -item -offset indent -compact
285.It
286File pointing to unallocated inode.
287.It
288Inode number out of range.
289.It
290Directories with unallocated blocks (holes).
291.It
292Dot or dot-dot not the first two entries of a directory
293or having the wrong inode number.
294.El
295.It
296Super Block checks:
297.Bl -item -offset indent -compact
298.It
299More blocks for inodes than there are in the file system.
300.It
301Bad free block map format.
302.It
303Total free block and/or free inode count incorrect.
304.El
305.El
306.Pp
307Orphaned files and directories (allocated but unreferenced) are,
308with the operator's concurrence, reconnected by
309placing them in the
310.Pa lost+found
311directory.
312The name assigned is the inode number.
313If the
314.Pa lost+found
315directory does not exist, it is created.
316If there is insufficient space its size is increased.
317.Sh FILES
318.Bl -tag -width /etc/fstab -compact
319.It Pa /etc/fstab
320contains default list of file systems to check.
321.El
322.Sh EXIT STATUS
323.Ex -std
324.Sh DIAGNOSTICS
325The diagnostics produced by
326.Nm
327are fully enumerated and explained in Appendix A of
328.Rs
329.%T "Fsck \- The UNIX File System Check Program"
330.Re
331.Sh SEE ALSO
332.Xr fs 5 ,
333.Xr fstab 5 ,
334.Xr fsck 8 ,
335.Xr fsdb 8 ,
336.Xr newfs 8 ,
337.Xr reboot 8
338