Searched +full:serial +full:- +full:to +full:- +full:powerline (Results 1 – 3 of 3) sorted by relevance
1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)3 ---5 $schema: http://devicetree.org/meta-schemas/core.yaml#10 - Frank Li <Frank.Li@nxp.com>13 The QCA7000 is a serial-to-powerline bridge with a host interface which could19 In order to use the QCA7000 as SPI device it must be defined as a child of a24 In order to use the QCA7000 as UART slave it must be defined as a child of a25 UART master in the device tree. It is possible to preconfigure the UART26 settings of the QCA7000 firmware, but it's not possible to change them during39 qca,legacy-mode:[all …]
3 The QCA7000 is a serial-to-powerline bridge with a host interface which could9 In order to use the QCA7000 as SPI device it must be defined as a child of a13 - compatible : Should be "qca,qca7000"14 - reg : Should specify the SPI chip select15 - interrupts : The first cell should specify the index of the source18 - spi-cpha : Must be set19 - spi-cpol : Must be set22 - spi-max-frequency : Maximum frequency of the SPI bus the chip can operate at.25 frequency to 8000000 Hertz.26 - qca,legacy-mode : Set the SPI data transfer of the QCA7000 to legacy mode.[all …]
5 # Date: 2025-10-18 03:15:018 # the PCI ID Project at https://pci-ids.ucw.cz/.11 # anything to contribute, please follow the instructions at the web site.14 # (version 2 or higher) or the 3-clause BSD License.25 # device device_name <-- single tab26 # subvendor subdevice subsystem_name <-- two tabs30 # This is a relabelled RTL-813931 8139 AT-2500TX V3 Ethernet41 7a09 PCI-to-PCI Bridge51 7a19 PCI-to-PCI Bridge[all …]