Home
last modified time | relevance | path

Searched +full:rdy +full:- +full:gpios (Results 1 – 18 of 18) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/bus/
H A Dts-nbus.txt4 Systems FPGA on the TS-4600 SoM.
7 - compatible : "technologic,ts-nbus"
8 - #address-cells : must be 1
9 - #size-cells : must be 0
10 - pwms : The PWM bound to the FPGA
11 - ts,data-gpios : The 8 GPIO pins connected to the data lines on the FPGA
12 - ts,csn-gpios : The GPIO pin connected to the csn line on the FPGA
13 - ts,txrx-gpios : The GPIO pin connected to the txrx line on the FPGA
14 - ts,strobe-gpios : The GPIO pin connected to the stobe line on the FPGA
15 - ts,ale-gpios : The GPIO pin connected to the ale line on the FPGA
[all …]
/freebsd/sys/contrib/device-tree/Bindings/mtd/
H A Dgpio-control-nand.txt8 - compatible : "gpio-control-nand"
9 - reg : should specify localbus chip select and size used for the chip. The
12 - #address-cells, #size-cells : Must be present if the device has sub-nodes
14 - gpios : Specifies the GPIO pins to control the NAND device. The order of
15 GPIO references is: RDY, nCE, ALE, CLE, and nWP. nCE and nWP are optional.
18 - bank-width : Width (in bytes) of the device. If not present, the width
20 - chip-delay : chip dependent delay for transferring data from array to
22 - gpio-control-nand,io-sync-reg : A 64-bit physical address for a read
28 The device tree may optionally contain sub-nodes describing partitions of the
33 gpio-nand@1,0 {
[all …]
H A Datmel-nand.txt4 Documentation/devicetree/bindings/memory-controllers/atmel,ebi.txt).
11 - compatible: should be one of the following
12 "atmel,at91rm9200-nand-controller"
13 "atmel,at91sam9260-nand-controller"
14 "atmel,at91sam9261-nand-controller"
15 "atmel,at91sam9g45-nand-controller"
16 "atmel,sama5d3-nand-controller"
17 "microchip,sam9x60-nand-controller"
18 - ranges: empty ranges property to forward EBI ranges definitions.
19 - #address-cells: should be set to 2.
[all …]
/freebsd/sys/contrib/device-tree/Bindings/spi/
H A Dfsl-imx-cspi.txt5 - compatible :
6 - "fsl,imx1-cspi" for SPI compatible with the one integrated on i.MX1
7 - "fsl,imx21-cspi" for SPI compatible with the one integrated on i.MX21
8 - "fsl,imx27-cspi" for SPI compatible with the one integrated on i.MX27
9 - "fsl,imx31-cspi" for SPI compatible with the one integrated on i.MX31
10 - "fsl,imx35-cspi" for SPI compatible with the one integrated on i.MX35
11 - "fsl,imx51-ecspi" for SPI compatible with the one integrated on i.MX51
12 - "fsl,imx53-ecspi" for SPI compatible with the one integrated on i.MX53 and later Soc
13 - "fsl,imx8mq-ecspi" for SPI compatible with the one integrated on i.MX8MQ
14 - "fsl,imx8mm-ecspi" for SPI compatible with the one integrated on i.MX8MM
[all …]
/freebsd/sys/contrib/device-tree/Bindings/iio/adc/
H A Dadi,ad7192.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Michael Hennerich <michael.hennerich@analog.com>
16 https://www.analog.com/media/en/technical-documentation/data-sheets/AD7192.pdf
21 - adi,ad7190
22 - adi,ad7192
23 - adi,ad7193
24 - adi,ad7194
25 - adi,ad7195
[all …]
H A Dadi,ad7124.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Stefan Popa <stefan.popa@analog.com>
16 https://www.analog.com/media/en/technical-documentation/data-sheets/AD7124-8.pdf
21 - adi,ad7124-4
22 - adi,ad7124-8
32 clock-names:
34 - const: mclk
40 rdy-gpios:
[all …]
H A Dadi,ad7173.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Ceclan Dumitru <dumitru.ceclan@analog.com>
15 The AD717x family offer a complete integrated Sigma-Delta ADC solution which
18 (Factory Automation PLC Input modules). The Sigma-Delta ADC is intended
23 The AD411X family encompasses a series of low power, low noise, 24-bit,
24 sigma-delta analog-to-digital converters that offer a versatile range of
26 fully differential/single-ended and bipolar voltage inputs.
29 https://www.analog.com/media/en/technical-documentation/data-sheets/AD4111.pdf
[all …]
H A Dadi,ad7780.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Michael Hennerich <michael.hennerich@analog.com>
13 The ad7780 is a sigma-delta analog to digital converter. This driver provides
20 https://www.analog.com/media/en/technical-documentation/data-sheets/AD7170.pdf
22 https://www.analog.com/media/en/technical-documentation/data-sheets/AD7171.pdf
24 https://www.analog.com/media/en/technical-documentation/data-sheets/ad7780.pdf
26 https://www.analog.com/media/en/technical-documentation/data-sheets/AD7781.pdf
31 - adi,ad7170
[all …]
H A Dadi,ad4170-4.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/iio/adc/adi,ad4170-4.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Analog Devices AD4170-4 and similar Analog to Digital Converters
10 - Marcelo Schmitt <marcelo.schmitt@analog.com>
13 Analog Devices AD4170-4 series of Sigma-delta Analog to Digital Converters.
15 https://www.analog.com/media/en/technical-documentation/data-sheets/ad4170-4.pdf
16 https://www.analog.com/media/en/technical-documentation/data-sheets/ad4190-4.pdf
17 https://www.analog.com/media/en/technical-documentation/data-sheets/ad4195-4.pdf
[all …]
/freebsd/sys/contrib/device-tree/src/arm/st/
H A Dstih418-b2199.dts1 // SPDX-License-Identifier: GPL-2.0-only
6 /dts-v1/;
8 #include <dt-bindings/gpio/gpio.h>
11 compatible = "st,stih418-b2199", "st,stih418";
14 stdout-path = &sbc_serial0;
28 compatible = "gpio-leds";
29 led-red {
31 gpios = <&pio4 1 GPIO_ACTIVE_HIGH>;
32 linux,default-trigger = "heartbeat";
34 led-green {
[all …]
H A Dstihxxx-b2120.dtsi1 // SPDX-License-Identifier: GPL-2.0-only
6 #include <dt-bindings/clock/stih407-clks.h>
7 #include <dt-bindings/gpio/gpio.h>
8 #include <dt-bindings/media/c8sectpfe.h>
11 compatible = "gpio-leds";
12 led-red {
14 gpios = <&pio4 1 GPIO_ACTIVE_HIGH>;
15 linux,default-trigger = "heartbeat";
17 led-green {
18 gpios = <&pio1 3 GPIO_ACTIVE_HIGH>;
[all …]
H A Dstih418-b2264.dts1 // SPDX-License-Identifier: GPL-2.0-only
6 /dts-v1/;
8 #include <dt-bindings/gpio/gpio.h>
11 compatible = "st,stih418-b2264", "st,stih418";
14 stdout-path = &sbc_serial0;
24 operating-points-v
[all...]
/freebsd/sys/contrib/device-tree/Bindings/input/touchscreen/
H A Diqs5xx.txt5 - compatible : Must be equal to one of the following:
10 - reg : I2C slave address for the device.
12 - interrupts : GPIO to which the device's active-high RDY
15 - reset-gpios : GPIO to which the device's active-low NRST
20 - touchscreen-min-x : See [2].
22 - touchscreen-min-y : See [2].
24 - touchscreen-size-x : See [2]. If this property is omitted, the
25 maximum x-coordinate is specified by the
28 - touchscreen-size-y : See [2]. If this property is omitted, the
29 maximum y-coordinate is specified by the
[all …]
H A Dazoteq,iqs7211.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jeff LaBundy <jeff@labundy.com>
13 The Azoteq IQS7210A, IQS7211A and IQS7211E trackpad and touchscreen control-
14 lers employ projected-capacitance sensing and can track two contacts.
21 - azoteq,iqs7210a
22 - azoteq,iqs7211a
23 - azoteq,iqs7211e
28 irq-gpios:
[all …]
/freebsd/sys/contrib/device-tree/src/mips/ni/
H A D169445.dts1 /dts-v1/;
4 #address-cells = <1>;
5 #size-cells = <1>;
9 #address-cells = <1>;
10 #size-cells = <0>;
25 compatible = "fixed-clock";
26 #clock-cells = <0>;
27 clock-frequency = <50000000>;
30 cpu_intc: interrupt-controller {
31 #address-cells = <0>;
[all …]
/freebsd/sys/contrib/device-tree/src/arm/nxp/imx/
H A Dimx6qdl-colibri.dtsi1 // SPDX-License-Identifier: GPL-2.0+ OR MIT
3 * Copyright 2014-2022 Toradex
8 #include <dt-bindings/gpio/gpio.h>
9 #include <dt-bindings/pwm/pwm.h>
17 /delete-property/ mmc2;
18 /delete-property/ mmc3;
22 compatible = "pwm-backlight";
23 brightness-levels = <0 45 63 88 119 158 203 255>;
24 default-brightness-level = <4>;
25 enable-gpios = <&gpio3 26 GPIO_ACTIVE_HIGH>; /* Colibri BL_ON */
[all …]
/freebsd/sys/contrib/device-tree/src/arm/microchip/
H A Dat91rm9200.dtsi1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * at91rm9200.dtsi - Device Tree Include file for AT91RM9200 family SoC
12 #include <dt-bindings/pinctrl/at91.h>
13 #include <dt-bindings/interrupt-controller/irq.h>
14 #include <dt-bindings/gpio/gpio.h>
15 #include <dt-bindings/clock/at91.h>
16 #include <dt-bindings/mfd/at91-usart.h>
19 #address-cells = <1>;
20 #size-cells = <1>;
23 interrupt-parent = <&aic>;
[all …]
/freebsd/sys/contrib/device-tree/Bindings/input/
H A Dazoteq,iqs7222.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jeff LaBundy <jeff@labundy.com>
21 - azoteq,iqs7222a
22 - azoteq,iqs7222b
23 - azoteq,iqs7222c
24 - azoteq,iqs7222d
29 irq-gpios:
32 Specifies the GPIO connected to the device's active-low RDY output.
[all …]