Home
last modified time | relevance | path

Searched full:qca7000 (Results 1 – 6 of 6) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/net/
H A Dqca,qca7000.txt1 * Qualcomm QCA7000
3 The QCA7000 is a serial-to-powerline bridge with a host interface which could
5 the QCA7000 firmware.
9 In order to use the QCA7000 as SPI device it must be defined as a child of a
13 - compatible : Should be "qca,qca7000"
26 - qca,legacy-mode : Set the SPI data transfer of the QCA7000 to legacy mode.
30 the QCA7000 is setup via GPIO pin strapping. If the
46 qca7000: ethernet@0 {
47 compatible = "qca,qca7000";
60 In order to use the QCA7000 as UART slave it must be defined as a child of a
[all …]
H A Dqca,qca7000.yaml4 $id: http://devicetree.org/schemas/net/qca,qca7000.yaml#
7 title: Qualcomm QCA7000
13 The QCA7000 is a serial-to-powerline bridge with a host interface which could
15 the QCA7000 firmware.
19 In order to use the QCA7000 as SPI device it must be defined as a child of a
24 In order to use the QCA7000 as UART slave it must be defined as a child of a
26 settings of the QCA7000 firmware, but it's not possible to change them during
31 const: qca,qca7000
42 Set the SPI data transfer of the QCA7000 to legacy mode.
46 the QCA7000 is setup via GPIO pin strapping. If the
[all …]
/freebsd/sys/contrib/device-tree/src/arm/nxp/mxs/
H A Dimx28-duckbill-2-spi.dts15 ethernet1 = &qca7000;
28 qca7000_pins: qca7000@0 {
52 qca7000: ethernet@0 { label
54 compatible = "qca,qca7000";
/freebsd/sys/contrib/device-tree/src/arm/nxp/imx/
H A Dimx6ull-tarragon-master.dts39 compatible = "qca,qca7000";
57 compatible = "qca,qca7000";
H A Dimx6ull-tarragon-slave.dts17 compatible = "qca,qca7000";
H A Dimx6ull-tarragon-slavext.dts39 compatible = "qca,qca7000";