Home
last modified time | relevance | path

Searched +full:netxbig +full:- +full:gpio +full:- +full:ext (Results 1 – 4 of 4) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/leds/
H A Dleds-netxbig.txt1 Binding for the CPLD LEDs (GPIO extension bus) found on some LaCie/Seagate
5 - compatible: "lacie,netxbig-leds".
6 - gpio-ext: Phandle for the gpio-ext bus.
9 - timers: Timer array. Each timer entry is represented by three integers:
10 Mode (gpio-ext bus), delay_on and delay_off.
12 Each LED is represented as a sub-node of the netxbig-leds device.
14 Required sub-node properties:
15 - mode-addr: Mode register address on gpio-ext bus.
16 - mode-val: Mode to value mapping. Each entry is represented by two integers:
17 A mode and the corresponding value on the gpio-ext bus.
[all …]
/freebsd/sys/contrib/device-tree/src/arm/marvell/
H A Dkirkwood-netxbig.dtsi1 // SPDX-License-Identifier: GPL-2.0
9 * Based on netxbig_v2-setup.c,
14 #include <dt-bindings/leds/leds-netxbig.h>
16 #include "kirkwood-6281.dtsi"
21 stdout-path = &uart0;
33 #address-cells = <1>;
34 #size-cells = <1>;
35 compatible = "mxicy,mx25l4005a", "jedec,spi-nor";
37 spi-max-frequency = <20000000>;
42 label = "u-boot";
[all …]
/freebsd/sys/contrib/device-tree/Bindings/gpio/
H A Dlacie,netxbig-gpio-ext.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/gpio/lacie,netxbig-gpio-ext.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: NetxBig GPIO extension bus
10 - Simon Guinot <simon.guinot@sequanux.org>
13 GPIO extension bus found on some LaCie/Seagate boards
19 - const: lacie,netxbig-gpio-ext
21 addr-gpios:
22 description: GPIOs representing the address register (LSB->MSB).
[all …]
H A Dnetxbig-gpio-ext.txt1 Binding for the GPIO extension bus found on some LaCie/Seagate boards
5 - compatible: "lacie,netxbig-gpio-ext".
6 - addr-gpios: GPIOs representing the address register (LSB -> MSB).
7 - data-gpios: GPIOs representing the data register (LSB -> MSB).
8 - enable-gpio: latches the new configuration (address, data) on raising edge.
12 netxbig_gpio_ext: netxbig-gpio-ext {
13 compatible = "lacie,netxbig-gpio-ext";
15 addr-gpios = <&gpio1 15 GPIO_ACTIVE_HIGH
18 data-gpios = <&gpio1 12 GPIO_ACTIVE_HIGH
21 enable-gpio = <&gpio0 29 GPIO_ACTIVE_HIGH>;