Home
last modified time | relevance | path

Searched +full:jh7110 +full:- +full:ispcrg (Results 1 – 4 of 4) sorted by relevance

/linux/Documentation/devicetree/bindings/media/
H A Dstarfive,jh7110-camss.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/media/starfive,jh7110-camss.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jack Zhu <jack.zhu@starfivetech.com>
11 - Changhuang Liang <changhuang.liang@starfivetech.com>
14 The Starfive CAMSS ISP is a Camera interface for Starfive JH7110 SoC. It
15 consists of a VIN controller (Video In Controller, a top-level control unit)
20 const: starfive,jh7110-camss
25 reg-names:
[all …]
/linux/Documentation/devicetree/bindings/clock/
H A Dstarfive,jh7110-ispcrg.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/clock/starfive,jh7110-ispcrg.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: StarFive JH7110 Image-Signal-Process Clock and Reset Generator
10 - Xingyu Wu <xingyu.wu@starfivetech.com>
14 const: starfive,jh7110-ispcrg
21 - description: ISP Top core
22 - description: ISP Top Axi
23 - description: NOC ISP Bus
[all …]
/linux/Documentation/devicetree/bindings/phy/
H A Dstarfive,jh7110-dphy-rx.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/phy/starfive,jh7110-dphy-rx.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: StarFive SoC JH7110 MIPI D-PHY Rx Controller
10 - Jack Zhu <jack.zhu@starfivetech.com>
11 - Changhuang Liang <changhuang.liang@starfivetech.com>
14 StarFive SoCs contain a MIPI CSI D-PHY based on M31 IP, used to
19 const: starfive,jh7110-dphy-rx
26 - description: config clock
[all …]
/linux/arch/riscv/boot/dts/starfive/
H A Djh7110-common.dtsi1 // SPDX-License-Identifier: GPL-2.0 OR MIT
7 /dts-v1/;
8 #include "jh7110.dtsi"
9 #include "jh7110-pinfunc.h"
10 #include <dt-bindings/gpio/gpio.h>
11 #include <dt-bindings/leds/common.h>
12 #include <dt-bindings/pinctrl/starfive,jh7110-pinctrl.h>
27 stdout-path = "serial0:115200n8";
33 bootph-pre-ram;
36 gpio-restart {
[all …]