Home
last modified time | relevance | path

Searched +full:debounce +full:- +full:press +full:- +full:ms (Results 1 – 15 of 15) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/sound/
H A Dti,ts3a227e.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Dylan Reid <dgreid@chromium.org>
14 The TS3A227E detect headsets of 3-ring and 4-ring standards and
16 handles key press detection in accordance with the Android audio
22 - ti,ts3a227e
34 - 0 # 2.1 V
35 - 1 # 2.2 V
36 - 2 # 2.3 V
[all …]
H A Dcs42l42.txt5 - compatible : "cirrus,cs42l42"
7 - reg : the I2C address of the device for I2C.
9 - VP-supply, VCP-supply, VD_FILT-supply, VL-supply, VA-supply :
15 - reset-gpios : a GPIO spec for the reset pin. If specified, it will be
18 - interrupts : IRQ line info CS42L42.
19 (See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
22 - cirrus,ts-inv : Boolean property. Sets the behaviour of the jack plug
31 - cirrus,ts-dbnc-rise : Debounce the rising edge of TIP_SENSE_PLUG. With no
32 debounce, the tip sense pin might be noisy on a plug event.
34 0 - 0ms,
[all …]
H A Dcirrus,cs42l42.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - patches@opensource.cirrus.com
13 The CS42L42 is a low-power audio codec designed for portable applications.
14 It provides a high-dynamic range, stereo DAC for audio playback and a mono
15 high-dynamic-range ADC for audio capture. There is an integrated headset
21 - cirrus,cs42l42
22 - cirrus,cs42l83
29 VP-supply:
[all …]
H A Dnau8824.txt6 - compatible : Must be "nuvoton,nau8824"
8 - reg : the I2C address of the device. This is either 0x1a (CSB=0) or 0x1b (CSB=1).
11 - nuvoton,jkdet-polarity: JKDET pin polarity. 0 - active high, 1 - active low.
13 - nuvoton,vref-impedance: VREF Impedance selection
14 0 - Open
15 1 - 25 kOhm
16 2 - 125 kOhm
17 3 - 2.5 kOhm
19 - nuvoton,micbias-voltage: Micbias voltage level.
20 0 - VDDA
[all …]
H A Dnau8825.txt6 - compatible : Must be "nuvoton,nau8825"
8 - reg : the I2C address of the device. This is either 0x1a (CSB=0) or 0x1b (CSB=1).
11 - nuvoton,jkdet-enable: Enable jack detection via JKDET pin.
12 - nuvoton,jkdet-pull-enable: Enable JKDET pin pull. If set - pin pull enabled,
14 - nuvoton,jkdet-pull-up: Pull-up JKDET pin. If set then JKDET pin is pull up, otherwise pull down.
15 - nuvoton,jkdet-polarity: JKDET pin polarity. 0 - active high, 1 - active low.
17 - nuvoton,vref-impedance: VREF Impedance selection
18 0 - Open
19 1 - 25 kOhm
20 2 - 125 kOhm
[all …]
H A Dnuvoton,nau8825.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - John Hsu <KCHSU0@nuvoton.com>
13 - $ref: dai-common.yaml#
18 - nuvoton,nau8825
26 nuvoton,jkdet-enable:
31 nuvoton,jkdet-pull-enable:
34 If set - pin pull enabled, otherwise pin in high impedance state.
37 nuvoton,jkdet-pull-up:
[all …]
H A Dnuvoton,nau8824.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - John Hsu <KCHSU0@nuvoton.com>
13 - $ref: dai-common.yaml#
18 - nuvoton,nau8824
23 '#sound-dai-cells':
29 nuvoton,jkdet-polarity:
34 - 0 # active high
35 - 1 # active low
[all …]
H A Dda7219.txt8 - compatible : Should be "dlg,da7219"
9 - reg: Specifies the I2C slave address
11 - interrupts : IRQ line info for DA7219.
12 (See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt for
15 - VDD-supply: VDD power supply for the device
16 - VDDMIC-supply: VDDMIC power supply for the device
17 - VDDIO-supply: VDDIO power supply for the device
22 - interrupt-names : Name associated with interrupt line. Should be "wakeup" if
24 - wakeup-source: Flag to indicate this device can wake system (suspend/resume).
26 - #clock-cells : Should be set to '<1>', two clock sources provided;
[all …]
H A Ddialog,da7219.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schema
[all...]
/freebsd/sys/contrib/device-tree/Bindings/input/
H A Dgpio-matrix-keypad.txt6 keypad can sense a key-press and key-release by means of GPIO lines and
10 - compatible: Should be "gpio-matrix-keypad"
11 - row-gpios: List of gpios used as row lines. The gpio specifier
14 - col-gpios: List of gpios used as column lines. The gpio specifier
17 - linux,keymap: The definition can be found at
18 bindings/input/matrix-keymap.txt
21 - linux,no-autorepeat: do no enable autorepeat feature.
22 - wakeup-source: use any event on keypad as wakeup event.
24 - debounce-delay-ms: debounce interval in milliseconds
25 - col-scan-delay-us: delay, measured in microseconds, that is needed
[all …]
H A Dazoteq,iqs7222.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schema
[all...]
H A Dmediatek,mt6779-keypad.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/input/mediatek,mt6779-keypad.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Mattijs Korpershoek <mkorpershoek@baylibre.com>
13 - $ref: /schemas/input/matrix-keymap.yaml#
16 Mediatek's Keypad controller is used to interface a SoC with a matrix-type
19 The keypad controller can sense a key-press and key-release and report the
25 - const: mediatek,mt6779-keypad
26 - items:
[all …]
/freebsd/sys/contrib/device-tree/src/arm/st/
H A Dste-href-tvk1281618-r3.dtsi1 // SPDX-License-Identifier: GPL-2.0-or-later
7 #include <dt-bindings/interrupt-controller/irq.h>
8 #include <dt-bindings/input/input.h>
12 compatible = "gpio-keys";
13 #address-cells = <1>;
14 #size-cells = <0>;
15 vdd-supply = <&ab8500_ldo_aux1_reg>;
16 pinctrl-names = "default";
17 pinctrl-0 = <&hall_tvk_mode>;
32 interrupt-parent = <&gpio2>;
[all …]
H A Dste-href-tvk1281618-r2.dtsi1 // SPDX-License-Identifier: GPL-2.0-or-later
6 #include <dt-bindings/interrupt-controller/irq.h>
7 #include <dt-bindings/input/input.h>
11 compatible = "gpio-keys";
12 #address-cell
[all...]
/freebsd/sys/contrib/device-tree/src/arm64/rockchip/
H A Drk3399-pinephone-pro.dts1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
9 * https://files.pine64.org/doc/PinePhonePro/PinephonePro-Schematic-V1.0-20211127.pdf
12 /dts-v1/;
13 #include <dt-bindings/input/gpio-keys.h>
14 #include <dt-bindings/input/linux-event-codes.h>
16 #include "rk3399-opp.dtsi"
20 compatible = "pine64,pinephone-pro", "rockchip,rk3399";
21 chassis-type = "handset";
30 stdout-path = "serial2:115200n8";
33 adc-keys {
[all …]