/* * CDDL HEADER START * * The contents of this file are subject to the terms of the * Common Development and Distribution License, Version 1.0 only * (the "License"). You may not use this file except in compliance * with the License. * * You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE * or http://www.opensolaris.org/os/licensing. * See the License for the specific language governing permissions * and limitations under the License. * * When distributing Covered Code, include this CDDL HEADER in each * file and include the License file at usr/src/OPENSOLARIS.LICENSE. * If applicable, add the following below this CDDL HEADER, with the * fields enclosed by brackets "[]" replaced with your own identifying * information: Portions Copyright [yyyy] [name of copyright owner] * * CDDL HEADER END */ /* * Copyright 2005 Sun Microsystems, Inc. All rights reserved. * Use is subject to license terms. */ #ifndef _SYS_SCSI_GENERIC_MODE_H #define _SYS_SCSI_GENERIC_MODE_H #pragma ident "%Z%%M% %I% %E% SMI" #ifdef __cplusplus extern "C" { #endif /* * * Defines and Structures for SCSI Mode Sense/Select data - generic * */ /* * Structures and defines common for all device types */ /* * Mode Sense/Select Header - Group 0 (6-byte). * * Mode Sense/Select data consists of a header, followed by zero or more * block descriptors, followed by zero or more mode pages. * */ struct mode_header { uchar_t length; /* number of bytes following */ uchar_t medium_type; /* device specific */ uchar_t device_specific; /* device specific parameters */ uchar_t bdesc_length; /* length of block descriptor(s), if any */ }; #define MODE_HEADER_LENGTH (sizeof (struct mode_header)) /* * Mode Sense/Select Header - Group 1 (10-bytes) */ struct mode_header_g1 { ushort_t length; /* number of bytes following */ uchar_t medium_type; /* device specific */ uchar_t device_specific; /* device specific parameters */ uchar_t reserved[2]; /* device specific parameters */ ushort_t bdesc_length; /* len of block descriptor(s), if any */ }; #define MODE_HEADER_LENGTH_G1 (sizeof (struct mode_header_g1)) /* * Block Descriptor. Zero, one, or more may normally follow the mode header. * * The density code is device specific. * * The 24-bit value described by blks_{hi, mid, lo} describes the number of * blocks which this block descriptor applies to. A value of zero means * 'the rest of the blocks on the device'. * * The 24-bit value described by blksize_{hi, mid, lo} describes the blocksize * (in bytes) applicable for this block descriptor. For Sequential Access * devices, if this value is zero, the block size will be derived from * the transfer length in I/O operations. * */ struct block_descriptor { uchar_t density_code; /* device specific */ uchar_t blks_hi; /* hi */ uchar_t blks_mid; /* mid */ uchar_t blks_lo; /* low */ uchar_t reserved; /* reserved */ uchar_t blksize_hi; /* hi */ uchar_t blksize_mid; /* mid */ uchar_t blksize_lo; /* low */ }; #define MODE_BLK_DESC_LENGTH (sizeof (struct block_descriptor)) #define MODE_PARAM_LENGTH (MODE_HEADER_LENGTH + MODE_BLK_DESC_LENGTH) /* * Define a macro to take an address of a mode header to the address * of the nth (0..n) block_descriptor, or NULL if there either aren't any * block descriptors or the nth block descriptor doesn't exist. */ #define BLOCK_DESCRIPTOR_ADDR(mhdr, bdnum) \ ((mhdr)->bdesc_length && ((unsigned)(bdnum)) < \ ((mhdr)->bdesc_length/(sizeof (struct block_descriptor)))) ? \ ((struct block_descriptor *)(((ulong_t)(mhdr))+MODE_HEADER_LENGTH+ \ ((bdnum) * sizeof (struct block_descriptor)))) : \ ((struct block_descriptor *)0) /* * Mode page header. Zero or more Mode Pages follow either the block * descriptors (if any), or the Mode Header. * * The 'ps' bit must be zero for mode select operations. * */ struct mode_page { #if defined(_BIT_FIELDS_LTOH) uchar_t code :6, /* page code number */ :1, /* reserved */ ps :1; /* 'Parameter Saveable' bit */ #elif defined(_BIT_FIELDS_HTOL) uchar_t ps :1, /* 'Parameter Saveable' bit */ :1, /* reserved */ code :6; /* page code number */ #else #error One of _BIT_FIELDS_LTOH or _BIT_FIELDS_HTOL must be defined #endif /* _BIT_FIELDS_LTOH */ uchar_t length; /* length of bytes to follow */ /* * Mode Page specific data follows right after this... */ }; /* * Define a macro to retrieve the first mode page. Could be more * general (for multiple mode pages). */ #define MODE_PAGE_ADDR(mhdr, type) \ ((type *)(((ulong_t)(mhdr))+MODE_HEADER_LENGTH+(mhdr)->bdesc_length)) /* * Page codes follow the following specification: * * Code Value(s) What * ---------------------------------------------------------------------- * 0x00 Vendor Unique (does not require page format) * * 0x02, 0x09, 0x0A pages for all Device Types * 0x1A, 0x1C * * 0x01, 0x03-0x08, pages for specific Device Type * 0x0B-0x19, 0x1B, * 0x1D-0x1F * * 0x20-0x3E Vendor Unique (requires page format) * * 0x3F Return all pages (valid for Mode Sense only) * */ /* * Page codes and page length values (all device types) */ #define MODEPAGE_DISCO_RECO 0x02 #define MODEPAGE_CACHING 0x08 #define MODEPAGE_PDEVICE 0x09 #define MODEPAGE_CTRL_MODE 0x0A #define MODEPAGE_POWER_COND 0x1A #define MODEPAGE_INFO_EXCPT 0x1C #define MODEPAGE_ALLPAGES 0x3F /* * Mode Select/Sense page structures (for all device types) */ /* * Disconnect/Reconnect Page */ struct mode_disco_reco { struct mode_page mode_page; /* common mode page header */ uchar_t buffer_full_ratio; /* write, how full before reconnect? */ uchar_t buffer_empty_ratio; /* read, how full before reconnect? */ ushort_t bus_inactivity_limit; /* how much bus quiet time for BSY- */ ushort_t disconect_time_limit; /* min to remain disconnected */ ushort_t connect_time_limit; /* min to remain connected */ ushort_t max_burst_size; /* max data burst size */ #if defined(_BIT_FIELDS_LTOH) uchar_t dtdc : 3, /* data transfer disconenct control */ dimm : 1, /* disconnect immediate */ fastat : 1, /* fair for status */ fawrt : 1, /* fair for write */ fard : 1, /* fair for read */ emdp : 1; /* enable modify data pointers */ #elif defined(_BIT_FIELDS_HTOL) uchar_t emdp : 1, /* enable modify data pointers */ fard : 1, /* fair for read */ fawrt : 1, /* fair for write */ fastat : 1, /* fair for status */ dimm : 1, /* disconnect immediate */ dtdc : 3; /* data transfer disconenct control */ #else #error One of _BIT_FIELDS_LTOH or _BIT_FIELDS_HTOL must be defined #endif /* _BIT_FIELDS_LTOH */ uchar_t reserved; ushort_t first_burst_sz; /* first burst size */ }; #define DTDC_DATADONE 0x01 /* * Target may not disconnect once * data transfer is started until * all data successfully transferred. */ #define DTDC_CMDDONE 0x03 /* * Target may not disconnect once * data transfer is started until * command completed. */ /* * Caching Page */ struct mode_caching { struct mode_page mode_page; /* common mode page header */ #if defined(_BIT_FIELDS_LTOH) uchar_t rcd : 1, /* Read Cache Disable */ mf : 1, /* Multiplication Factor */ wce : 1, /* Write Cache Enable */ : 5; /* Reserved */ uchar_t write_ret_prio : 4, /* Write Retention Priority */ dmd_rd_ret_prio : 4; /* Demand Read Retention Priority */ #elif defined(_BIT_FIELDS_HTOL) uchar_t : 5, /* Reserved */ wce : 1, /* Write Cache Enable */ mf : 1, /* Multiplication Factor */ rcd : 1; /* Read Cache Disable */ uchar_t dmd_rd_ret_prio : 4, /* Demand Read Retention Priority */ write_ret_prio : 4; /* Write Retention Priority */ #else #error One of _BIT_FIELDS_LTOH or _BIT_FIELDS_HTOL must be defined #endif /* _BIT_FIELDS_LTOH */ ushort_t pf_dsbl_trans_len; /* Disable prefetch transfer length */ ushort_t min_prefetch; /* Minimum Prefetch */ ushort_t max_prefetch; /* Maximum Prefetch */ ushort_t max_prefetch_ceiling; /* Maximum Prefetch Ceiling */ }; /* * Peripheral Device Page */ struct mode_pdevice { struct mode_page mode_page; /* common mode page header */ ushort_t if_ident; /* interface identifier */ uchar_t reserved[4]; /* reserved */ uchar_t vendor_uniqe[1]; /* vendor unique data */ }; #define PDEV_SCSI 0x0000 /* scsi interface */ #define PDEV_SMD 0x0001 /* SMD interface */ #define PDEV_ESDI 0x0002 /* ESDI interface */ #define PDEV_IPI2 0x0003 /* IPI-2 interface */ #define PDEV_IPI3 0x0004 /* IPI-3 interface */ /* * Control Mode Page * * Note: This structure is incompatible with previous SCSI * implementations. See for an * alternative form of this structure. They can be * distinguished by the length of data returned * from a MODE SENSE command. */ #define PAGELENGTH_MODE_CONTROL_SCSI3 0x0A struct mode_control_scsi3 { struct mode_page mode_page; /* common mode page header */ #if defined(_BIT_FIELDS_LTOH) uchar_t rlec : 1, /* Report Log Exception bit */ gltsd : 1, /* global logging target save disable */ d_sense : 1, /* Use descriptor sense data (SPC-3) */ : 5; uchar_t qdisable: 1, /* Queue disable */ que_err : 1, /* Queue error */ : 2, que_mod : 4; /* Queue algorithm modifier */ uchar_t eanp : 1, /* Enable AEN permission */ uaaenp : 1, /* Unit attention AEN permission */ raenp : 1, /* Ready AEN permission */ : 1, bybths : 1, /* By both RESET signal */ byprtm : 1, /* By port message */ rac : 1, /* report a check */ eeca : 1; /* enable extended contingent */ /* allegiance (only pre-SCSI-3) */ #elif defined(_BIT_FIELDS_HTOL) uchar_t : 5, d_sense : 1, /* Use descriptor sense data (SPC-3) */ gltsd : 1, /* global logging target save disable */ rlec : 1; /* Report Log Exception bit */ uchar_t que_mod : 4, /* Queue algorithm modifier */ : 2, que_err : 1, /* Queue error */ qdisable: 1; /* Queue disable */ uchar_t eeca : 1, /* enable extended contingent */ /* allegiance (only pre-SCSI-3) */ rac : 1, /* report a check */ byprtm : 1, /* By port message */ bybths : 1, /* By both RESET signal */ : 1, raenp : 1, /* Ready AEN permission */ uaaenp : 1, /* Unit attention AEN permission */ eanp : 1; /* Enable AEN permission */ #else #error One of _BIT_FIELDS_LTOH or _BIT_FIELDS_HTOL must be defined #endif /* _BIT_FIELDS_LTOH */ uchar_t reserved; ushort_t ready_aen_holdoff; /* Ready AEN holdoff period */ ushort_t busy_timeout; /* Busy timeout period */ uchar_t reserved_2[2]; }; #define CTRL_QMOD_RESTRICT 0x0 #define CTRL_QMOD_UNRESTRICT 0x1 #ifdef __cplusplus } #endif /* * Include known generic device specific mode definitions and structures */ #include /* * Include implementation specific mode information */ #include #endif /* _SYS_SCSI_GENERIC_MODE_H */