/* * CDDL HEADER START * * The contents of this file are subject to the terms of the * Common Development and Distribution License (the "License"). * You may not use this file except in compliance with the License. * * You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE * or http://www.opensolaris.org/os/licensing. * See the License for the specific language governing permissions * and limitations under the License. * * When distributing Covered Code, include this CDDL HEADER in each * file and include the License file at usr/src/OPENSOLARIS.LICENSE. * If applicable, add the following below this CDDL HEADER, with the * fields enclosed by brackets "[]" replaced with your own identifying * information: Portions Copyright [yyyy] [name of copyright owner] * * CDDL HEADER END */ /* * Copyright(c) 2007-2008 Intel Corporation. All rights reserved. */ /* * Copyright 2008 Sun Microsystems, Inc. All rights reserved. * Use is subject to license terms. */ #include "igb_osdep.h" #include "igb_api.h" s32 e1000_alloc_zeroed_dev_spec_struct(struct e1000_hw *hw, u32 size) { hw->dev_spec = kmem_zalloc(size, KM_SLEEP); return (E1000_SUCCESS); } void e1000_free_dev_spec_struct(struct e1000_hw *hw) { if (hw->dev_spec == NULL) return; kmem_free(hw->dev_spec, hw->dev_spec_size); hw->dev_spec = NULL; } void e1000_pci_set_mwi(struct e1000_hw *hw) { uint16_t val = hw->bus.pci_cmd_word | CMD_MEM_WRT_INVALIDATE; e1000_write_pci_cfg(hw, PCI_COMMAND_REGISTER, &val); } void e1000_pci_clear_mwi(struct e1000_hw *hw) { uint16_t val = hw->bus.pci_cmd_word & ~CMD_MEM_WRT_INVALIDATE; e1000_write_pci_cfg(hw, PCI_COMMAND_REGISTER, &val); } void e1000_write_pci_cfg(struct e1000_hw *hw, uint32_t reg, uint16_t *value) { pci_config_put16(OS_DEP(hw)->cfg_handle, reg, *value); } void e1000_read_pci_cfg(struct e1000_hw *hw, uint32_t reg, uint16_t *value) { *value = pci_config_get16(OS_DEP(hw)->cfg_handle, reg); } /* * The real intent of this routine is to return the value from pci-e * config space at offset reg into the capability space. * ICH devices are "PCI Express"-ish. They have a configuration space, * but do not contain PCI Express Capability registers, so this returns * the equivalent of "not supported" */ int32_t e1000_read_pcie_cap_reg(struct e1000_hw *hw, uint32_t reg, uint16_t *value) { *value = pci_config_get16(OS_DEP(hw)->cfg_handle, PCI_EX_CONF_CAP + reg); return (0); } /* * Enables PCI-Express master access. * * hw: Struct containing variables accessed by shared code * * returns: - none. */ void e1000_enable_pciex_master(struct e1000_hw *hw) { uint32_t ctrl; if (hw->bus.type != e1000_bus_type_pci_express) return; ctrl = E1000_READ_REG(hw, E1000_CTRL); ctrl &= ~E1000_CTRL_GIO_MASTER_DISABLE; E1000_WRITE_REG(hw, E1000_CTRL, ctrl); } /* * e1000_rar_set_vmdq - Clear the RAR registers */ void e1000_rar_clear(struct e1000_hw *hw, uint32_t index) { uint32_t rar_high; /* Make the hardware the Address invalid by setting the clear bit */ rar_high = ~E1000_RAH_AV; E1000_WRITE_REG_ARRAY(hw, E1000_RA, ((index << 1) + 1), rar_high); E1000_WRITE_FLUSH(hw); } /* * e1000_rar_set_vmdq - Set the RAR registers for VMDq */ void e1000_rar_set_vmdq(struct e1000_hw *hw, const uint8_t *addr, uint32_t index, uint32_t vmdq_mode, uint8_t qsel) { uint32_t rar_low, rar_high; /* * NIC expects these in little endian so reverse the byte order * from network order (big endian) to little endian. */ rar_low = ((uint32_t)addr[0] | ((uint32_t)addr[1] << 8) | ((uint32_t)addr[2] << 16) | ((uint32_t)addr[3] << 24)); rar_high = ((uint32_t)addr[4] | ((uint32_t)addr[5] << 8)); /* Indicate to hardware the Address is Valid. */ rar_high |= E1000_RAH_AV; /* Set que selector based on vmdq mode */ switch (vmdq_mode) { default: case E1000_VMDQ_OFF: break; case E1000_VMDQ_MAC: rar_high |= (qsel << 18); break; case E1000_VMDQ_MAC_RSS: rar_high |= 1 << (18 + qsel); break; } /* write to receive address registers */ E1000_WRITE_REG_ARRAY(hw, E1000_RA, (index << 1), rar_low); E1000_WRITE_REG_ARRAY(hw, E1000_RA, ((index << 1) + 1), rar_high); E1000_WRITE_FLUSH(hw); }