// SPDX-License-Identifier: BSD-3-Clause /* * Copyright (c) 2021, Linaro Limited */ #include #include #include #include / { thermal-zones { pmm8155au-1-thermal { polling-delay-passive = <100>; thermal-sensors = <&pmm8155au_1_temp>; trips { trip0 { temperature = <95000>; hysteresis = <0>; type = "passive"; }; trip1 { temperature = <115000>; hysteresis = <0>; type = "hot"; }; trip2 { temperature = <145000>; hysteresis = <0>; type = "critical"; }; }; }; }; }; &spmi_bus { pmic@0 { compatible = "qcom,pmm8155au", "qcom,spmi-pmic"; reg = <0x0 SPMI_USID>; #address-cells = <1>; #size-cells = <0>; pon: pon@800 { compatible = "qcom,pm8916-pon"; reg = <0x0800>; pwrkey { compatible = "qcom,pm8941-pwrkey"; interrupts = <0x0 0x8 0x0 IRQ_TYPE_EDGE_BOTH>; debounce = <15625>; bias-pull-up; linux,code = ; status = "disabled"; }; }; pmm8155au_1_temp: temp-alarm@2400 { compatible = "qcom,spmi-temp-alarm"; reg = <0x2400>; interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_BOTH>; io-channels = <&pmm8155au_1_adc ADC5_DIE_TEMP>; io-channel-names = "thermal"; #thermal-sensor-cells = <0>; }; pmm8155au_1_adc: adc@3100 { compatible = "qcom,spmi-adc5"; reg = <0x3100>; #address-cells = <1>; #size-cells = <0>; #io-channel-cells = <1>; interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>; channel@0 { reg = ; qcom,pre-scaling = <1 1>; label = "ref_gnd"; }; channel@1 { reg = ; qcom,pre-scaling = <1 1>; label = "vref_1p25"; }; channel@6 { reg = ; qcom,pre-scaling = <1 1>; label = "die_temp"; }; }; pmm8155au_1_adc_tm: adc-tm@3500 { compatible = "qcom,spmi-adc-tm5"; reg = <0x3500>; interrupts = <0x0 0x35 0x0 IRQ_TYPE_EDGE_RISING>; #thermal-sensor-cells = <1>; #address-cells = <1>; #size-cells = <0>; status = "disabled"; }; pmm8155au_1_rtc: rtc@6000 { compatible = "qcom,pm8941-rtc"; reg = <0x6000>, <0x6100>; reg-names = "rtc", "alarm"; interrupts = <0x0 0x61 0x1 IRQ_TYPE_NONE>; status = "disabled"; }; pmm8155au_1_gpios: gpio@c000 { compatible = "qcom,pmm8155au-gpio", "qcom,spmi-gpio"; reg = <0xc000>; gpio-controller; #gpio-cells = <2>; gpio-ranges = <&pmm8155au_1_gpios 0 0 10>; interrupt-controller; #interrupt-cells = <2>; }; }; pmic@1 { compatible = "qcom,pmm8155au", "qcom,spmi-pmic"; reg = <0x1 SPMI_USID>; #address-cells = <1>; #size-cells = <0>; }; };