// SPDX-License-Identifier: BSD-3-Clause /* * Copyright (c) 2020, Konrad Dybcio */ #include #include #include #include #include / { thermal-zones { pm660-thermal { polling-delay-passive = <250>; thermal-sensors = <&pm660_temp>; trips { pm660_alert0: pm660-alert0 { temperature = <95000>; hysteresis = <2000>; type = "passive"; }; pm660_crit: pm660-crit { temperature = <125000>; hysteresis = <2000>; type = "critical"; }; }; }; }; }; &spmi_bus { pmic@0 { compatible = "qcom,pm660", "qcom,spmi-pmic"; reg = <0x0 SPMI_USID>; #address-cells = <1>; #size-cells = <0>; rtc@6000 { compatible = "qcom,pm8941-rtc"; reg = <0x6000>, <0x6100>; reg-names = "rtc", "alarm"; interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>; }; pon: pon@800 { compatible = "qcom,pm8998-pon"; reg = <0x800>; mode-bootloader = <0x2>; mode-recovery = <0x1>; pon_pwrkey: pwrkey { compatible = "qcom,pm8941-pwrkey"; interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>; debounce = <15625>; bias-pull-up; linux,code = ; status = "disabled"; }; pon_resin: resin { compatible = "qcom,pm8941-resin"; interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>; debounce = <15625>; bias-pull-up; status = "disabled"; }; }; pm660_charger: charger@1000 { compatible = "qcom,pm660-charger"; reg = <0x1000>; interrupts = <0x0 0x13 0x4 IRQ_TYPE_EDGE_BOTH>, <0x0 0x12 0x2 IRQ_TYPE_EDGE_BOTH>, <0x0 0x16 0x1 IRQ_TYPE_EDGE_RISING>, <0x0 0x13 0x6 IRQ_TYPE_EDGE_RISING>; interrupt-names = "usb-plugin", "bat-ov", "wdog-bark", "usbin-icl-change"; io-channels = <&pm660_rradc 3>, <&pm660_rradc 4>; io-channel-names = "usbin_i", "usbin_v"; status = "disabled"; }; pm660_temp: temp-alarm@2400 { compatible = "qcom,spmi-temp-alarm"; reg = <0x2400>; interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_RISING>; io-channels = <&pm660_adc ADC5_DIE_TEMP>; io-channel-names = "thermal"; #thermal-sensor-cells = <0>; }; pm660_adc: adc@3100 { compatible = "qcom,spmi-adc-rev2"; reg = <0x3100>; interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>; #address-cells = <1>; #size-cells = <0>; #io-channel-cells = <1>; channel@0 { reg = ; qcom,decimation = <1024>; qcom,pre-scaling = <1 1>; label = "ref_gnd"; }; channel@1 { reg = ; qcom,decimation = <1024>; qcom,pre-scaling = <1 1>; label = "vref_1p25"; }; channel@6 { reg = ; qcom,decimation = <1024>; qcom,pre-scaling = <1 1>; label = "die_temp"; }; channel@4c { reg = ; qcom,pre-scaling = <1 1>; qcom,decimation = <1024>; qcom,hw-settle-time = <200>; qcom,ratiometric; label = "xo_therm"; }; channel@4d { reg = ; qcom,pre-scaling = <1 1>; qcom,decimation = <1024>; qcom,hw-settle-time = <200>; qcom,ratiometric; label = "msm_therm"; }; channel@4e { reg = ; qcom,pre-scaling = <1 1>; qcom,decimation = <1024>; qcom,hw-settle-time = <200>; qcom,ratiometric; label = "emmc_therm"; }; channel@4f { reg = ; qcom,pre-scaling = <1 1>; qcom,decimation = <1024>; qcom,hw-settle-time = <200>; qcom,ratiometric; label = "pa_therm0"; }; channel@50 { reg = ; qcom,pre-scaling = <1 1>; qcom,decimation = <1024>; qcom,hw-settle-time = <200>; qcom,ratiometric; label = "pa_therm1"; }; channel@51 { reg = ; qcom,pre-scaling = <1 1>; qcom,decimation = <1024>; qcom,hw-settle-time = <200>; qcom,ratiometric; label = "quiet_therm"; }; channel@83 { reg = ; qcom,decimation = <1024>; qcom,pre-scaling = <1 3>; label = "vph_pwr"; }; channel@85 { reg = ; qcom,decimation = <1024>; qcom,pre-scaling = <1 3>; label = "vcoin"; }; }; pm660_rradc: adc@4500 { compatible = "qcom,pm660-rradc"; reg = <0x4500>; #io-channel-cells = <1>; status = "disabled"; }; pm660_gpios: gpio@c000 { compatible = "qcom,pm660-gpio", "qcom,spmi-gpio"; reg = <0xc000>; gpio-controller; gpio-ranges = <&pm660_gpios 0 0 13>; #gpio-cells = <2>; interrupt-controller; #interrupt-cells = <2>; }; }; pmic@1 { compatible = "qcom,pm660", "qcom,spmi-pmic"; reg = <0x1 SPMI_USID>; #address-cells = <1>; #size-cells = <0>; pm660_spmi_regulators: regulators { compatible = "qcom,pm660-regulators"; }; }; };