Lines Matching +full:signal +full:- +full:to +full:- +full:noise

1 /* SPDX-License-Identifier: GPL-2.0-only */
17 	{ pr_err("while sending 0x%04x to 0x%04x.", val, reg); return -EREMOTEIO; }
139 /* impulse noise parameter */
159  * Dual Automatic-Gain-Control
160  * - gains RF in tuner (AGC1)
161  * - gains IF after filtering (AGC2)
164 /* also from 16 to 18 */
173 /* phase noise */
174 /* 36 is set when setting the impulse noise */
255 /* phase noise compensation inhibition */
297  * data diversity when having more than one chip on-board
313 /* time frame for Bit-Error-Rate calculation */
320 /* 142 - 152 FIFO parameters
350  * regs 153-168
358  * USB devices have to use 'slave'-mode
443 /* total RF power (16), can be used for signal strength */
460 /* noise power (24) */
468  * signal power (16), this and the above can be
469  * used to calculate the signal/noise - ratio
479  * the following registers can be used to get TPS-information.
480  * The values are according to the DVB-T standard.
486 /* QAM from TPS (2) (values according to DIB3000MB_REG_QAM) */
492 /* alpha from TPS (3) (values according to DIB3000MB_REG_VIT_ALPHA) */
495 /* code rate high priority from TPS (3) (values according to DIB3000MB_FEC_*) */
501 /* guard time from TPS (2) (values according to DIB3000MB_REG_GUARD_TIME */
504 /* fft size from TPS (2) (values according to DIB3000MB_REG_FFT) */