Lines Matching +full:stmpe +full:- +full:pwm
1 # SPDX-License-Identifier: GPL-2.0-only
60 non-sleeping contexts. They can make bitbanged serial protocols
81 numberspace-based functionalities of the sysfs interface.
137 Enables support for the idio-16 library functions. The idio-16 library
139 ACCES IDIO-16 family such as the 104-IDIO-16 and the PCI-IDIO-16.
141 If built as a module its name will be gpio-idio-16.
147 tristate "GPIO driver for 74xx-ICs with MMIO access"
151 Say yes here to support GPIO functionality for 74xx-compatible ICs
166 If driver is built as a module it will be called gpio-altera.
341 tristate "Generic memory-mapped GPIO controller support (MMIO platform device)"
344 Say yes here to support basic platform_device memory-mapped GPIO controllers.
347 tristate "Intel Granite Rapids-D vGPIO support"
354 - Intel Granite Rapids-D
362 be called gpio-graniterapids.
381 This GPIO controller supports double-edge interrupt and multi-core
399 ICH-based chipsets. Currently supported devices: ICH6, ICH7, ICH8
429 bool "Loongson-2/3 GPIO support"
432 Driver for GPIO functionality on Loongson-2F/3A/3B processors.
482 created by attaching a 16-bit latch to the bus.
552 Say yes here to support the on-chip GPIO lines on the OCTEON
586 tristate "Renesas R-Car and RZ/G GPIO support"
590 Say yes here to support GPIO on Renesas R-Car or RZ/G SoCs.
610 are grouped in four 8-bit wide ports.
617 A 32-bit single register GPIO fixed in/out implementation. This
653 maintain their value during backup/self-refresh.
671 via a SIOX bus and have a number of fixed-direction I/O lines.
679 This is a single-register MMIO GPIO driver for complex cases
730 - Elkhart Lake
731 - Merrifield
733 If built as a module its name will be gpio-tangier.
763 tristate "TS-4800 DIO blocks and compatibles"
768 This driver support TS-4800 FPGA GPIO controllers.
771 tristate "Cavium ThunderX/OCTEON-TX GPIO"
778 Say yes here to support the on-chip GPIO lines on the ThunderX
779 and OCTEON-TX families of SoCs.
816 bool "APM X-Gene GPIO controller support"
819 This driver is to support the GPIO block within the APM X-Gene SoC
825 tristate "APM X-Gene GPIO standby controller support"
831 This driver supports the GPIO block within the APM X-Gene
873 tristate "ZynqMP ps-mode pin GPIO configuration driver"
877 Say yes here to support the ZynqMP ps-mode pin GPIO configuration
880 This ps-mode pin GPIO driver is based on GPIO framework. PS_MODE
881 is 4-bits boot mode pins. It sets and gets the status of
882 the ps-mode pin. Every pin can be configured as input/output.
892 tristate "GPIO support for AMD Fusion Controller Hub (G-series SOCs)"
895 as found on G-series SOCs (e.g. GX-412TC).
898 needs to be provided with platform-specific configuration.
909 ARMv7-based SoCs.
918 IDT 79RC3243X-based devices like Mikrotik RB532.
921 be called gpio-idt3243x.
925 menu "Port-mapped I/O GPIO drivers"
951 If built as a module its name will be gpio-i8255.
954 tristate "ACCES 104-DIO-48E GPIO support"
963 Enables GPIO support for the ACCES 104-DIO-48E series (104-DIO-48E,
964 104-DIO-24E). The base port addresses for the devices may be
969 tristate "ACCES 104-IDIO-16 GPIO support"
975 Enables GPIO support for the ACCES 104-IDIO-16 family (104-IDIO-16,
976 104-IDIO-16E, 104-IDO-16, 104-IDIO-8, 104-IDIO-8E, 104-IDO-8). The
982 tristate "ACCES 104-IDI-48 GPIO support"
990 Enables GPIO support for the ACCES 104-IDI-48 family (104-IDI-48A,
991 104-IDI-48AC, 104-IDI-48B, 104-IDI-48BC). The base port addresses for
997 tristate "Fintek and Nuvoton Super-I/O GPIO support"
999 This option enables support for GPIOs found on Fintek Super-I/O
1001 As well as Nuvoton Super-I/O chip NCT6126D.
1004 be called f7188x-gpio.
1007 tristate "Diamond Systems GPIO-MM GPIO support"
1013 Enables GPIO support for the Diamond Systems GPIO-MM and GPIO-MM-12.
1015 The Diamond Systems GPIO-MM device features 48 lines of digital I/O
1048 active during S3. The suspend-powered GPIOs can be used to wake the
1049 system from the Suspend-to-RAM state.
1055 Twenty-one are powered by the core power rail and 9 from the
1068 be called gpio-sch311x.
1071 tristate "TS-5500 DIO blocks and compatibles"
1076 blocks of the TS-5500: DIO1, DIO2 and the LCD port, and the TS-5600
1089 boot-time parameter "gpio_winbond.gpios" with a bitmask of GPIO
1093 be called gpio-winbond.
1114 tristate "Avionic Design N-bit GPIO expander"
1133 be called gpio-fxl6408.
1140 GPIO driver for ADI DS4520 I2C-based GPIO expander.
1144 be called gpio-ds4520.
1151 Expander. This is used at least on the Cambria GW2358-4.
1157 GPIO driver for Maxim MAX7300 I2C-based GPIO expander.
1160 tristate "MAX7319, MAX7320-7327 I2C Port Expanders"
1162 Say yes here to support the MAX7319, MAX7320-7327 series of I2C
1164 Input (designated by 'I'), Push-Pull Output ('O'), or Open-Drain
1189 Say yes here to provide access to several register-oriented
1218 tristate "PCA9570 4-Bit I2C GPO expander"
1223 be called gpio-pca9570.
1230 Say yes here to provide access to most "quasi-bidirectional" I2C
1247 This driver provides an in-kernel interface to those GPIOs using
1248 platform-neutral GPIO calls.
1251 tristate "TPIC2810 8-Bit I2C GPO expander"
1256 be called gpio-tpic2810.
1264 Series supported include TS-4100, TS-4900, TS-7970 and TS-7990.
1274 This option enables support for on-chip GPIO found
1307 will be called gpio-bd71815.
1319 will be called gpio-bd71828.
1330 will be called gpio-bd9571mwv.
1340 called gpio-cgbc.
1350 will be called gpio-cros-ec.
1359 Say Yes if you have a Intel SoC-based tablet with Crystal Cove PMIC
1363 called gpio-crystalcove.
1391 If driver is built as a module it will be called gpio-da9055.
1403 will be called gpio-dln2.
1422 be called gpio-elkhartlake.
1425 tristate "Janz VMOD-TTL Digital IO Module"
1428 This enables support for the Janz VMOD-TTL Digital IO module.
1440 called gpio-kempld.
1452 will be called gpio-ljca.
1470 called gpio-lp873x.
1480 called gpio-lp87565.
1490 called gpio-macsmc.
1504 Allows to use MAX7360 I/O Expander PWM lines as GPIO and keypad COL
1508 called gpio-max7360.
1538 called gpio-max77759.
1550 called gpio-nct6694.
1595 called gpio-sl28cpld.
1598 tristate "STMPE GPIOs"
1603 This enables support for the GPIOs found on the STMPE I/O
1629 they are input-only or output-only type.
1632 module will be called gpio-tn48m.
1689 There are 7 GPIOs and few sensor-related GPIOs supported
1695 tristate "TQ-Systems TQMx86 GPIO"
1706 Say yes here to access the GPIO signals of various multi-function
1723 Say Yes if you have an Intel SoC-based tablet with Whiskey Cove PMIC
1727 called gpio-wcove.
1775 This chip can be found on Miro, Hauppauge and STB TV-cards.
1780 Documentation/driver-api/gpio/bt8xxgpio.rst
1815 This controller should be used in parallel with pinctrl-mlxbf3 to
1817 This driver can also be built as a module called mlxbf3-gpio.
1826 Hub) which is for IVI (In-Vehicle Infotainment) use.
1846 tristate "ACCES PCI-IDIO-16 GPIO support"
1850 Enables GPIO support for the ACCES PCI-IDIO-16. An interrupt is
1856 tristate "ACCES PCIe-IDIO-24 GPIO support"
1862 Enables GPIO support for the ACCES PCIe-IDIO-24 family (PCIe-IDIO-24,
1863 PCIe-IDI-24, PCIe-IDO-24, PCIe-IDIO-12). An interrupt is generated
1869 tristate "RDC R-321x GPIO support"
1890 tristate "74x164 serial-in/parallel-out 8-bits shift register"
1892 Driver for 74x164 compatible serial-in/parallel-out 8-outputs
1901 MAX31953 and MAX31963 industrial serializer, a daisy-chainable
1910 GPIO driver for Maxim MAX7301 SPI-based GPIO expander.
1913 tristate "Freescale MC33880 high-side/low-side switch"
1915 SPI driver for Freescale MC33880 high-side/low-side switch.
1919 tristate "Generic parallel-in/serial-out shift register"
1921 GPIO driver for SPI compatible parallel-in/serial-out shift
1925 tristate "EXAR XRA1403 16-bit GPIO expander"
1928 GPIO driver for EXAR XRA1403 16-bit SPI-based GPIO expander.
1985 - Assign permissions for a collection of GPIO lines to a user,
1986 - Export a collection of GPIO lines to a virtual machine,
1987 - Provide a generic driver for a GPIO-operated device in an
2001 This module is DEPRECATED. Please consider using gpio-sim instead.
2006 tools/testing/selftests/gpio/gpio-mockup.sh. Reference the usage in
2014 Say Y here to enable guest support for virtio-based GPIO controllers.
2025 This enables the GPIO simulator - a configfs-based GPIO testing
2029 tristate "Proxy driver for non-exclusive GPIOs"
2034 This enables the GPIO shared proxy driver - an abstraction layer
2046 GPIOs. Use the 'tools/gpio/gpio-sloppy-logic-analyzer' script with
2049 analyzer which can be affected by latencies, non-deterministic code
2054 'gpio-sloppy-logic-analyzer'.
2063 Say Y here to enable the configurable, configfs-based virtual GPIO
2067 hot-unplug handling in GPIOLIB.