Lines Matching +full:audio +full:- +full:aux +full:- +full:devs

1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
3 // Based on sun50i-a64-pine64.dts, which is:
6 /dts-v1/;
8 #include "sun50i-a64-sopine.dtsi"
12 	compatible = "pine64,sopine-baseboard", "pine64,sopine",
13 		     "allwinner,sun50i-a64";
25 		stdout-path = "serial0:115200n8";
28 	hdmi-connector {
29 		compatible = "hdmi-connector";
34 				remote-endpoint = <&hdmi_out_con>;
40 		compatible = "regulator-fixed";
41 		regulator-name = "vcc1v8";
42 		regulator-min-microvolt = <1800000>;
43 		regulator-max-microvolt = <1800000>;
80 	pinctrl-names = "default";
81 	pinctrl-0 = <&rgmii_pins>;
82 	phy-mode = "rgmii-txid";
83 	phy-handle = <&ext_rgmii_phy>;
84 	phy-supply = <&reg_dc1sw>;
89 	hvcc-supply = <&reg_dldo1>;
95 		remote-endpoint = <&hdmi_con_in>;
100 	ext_rgmii_phy: ethernet-phy@1 {
101 		compatible = "ethernet-phy-ieee802.3-c22";
108 	pinctrl-names = "default";
109 	pinctrl-0 = <&mmc1_pins>;
110 	vmmc-supply = <&reg_dldo4>;
111 	vqmmc-supply = <&reg_eldo1>;
112 	bus-width = <4>;
113 	non-removable;
118 	pinctrl-names = "default";
119 	pinctrl-0 = <&mmc2_pins>;
120 	vmmc-supply = <&reg_dcdc1>;
121 	vqmmc-supply = <&reg_vcc1v8>;
122 	bus-width = <8>;
123 	non-removable;
124 	cap-mmc-hw-reset;
125 	mmc-hs200-1_8v;
143 	regulator-enable-ramp-delay = <100000>;
144 	regulator-name = "vcc-phy";
148 	regulator-min-microvolt = <3300000>;
149 	regulator-max-microvolt = <3300000>;
150 	regulator-name = "vcc-hdmi";
154 	regulator-min-microvolt = <3300000>;
155 	regulator-max-microvolt = <3300000>;
156 	regulator-name = "vcc-mipi";
160 	regulator-min-microvolt = <3300000>;
161 	regulator-max-microvolt = <3300000>;
162 	regulator-name = "vcc-wifi";
166 	vcc-hdmi-supply = <&reg_dldo1>;
170 	simple-audio-card,aux-devs = <&codec_analog>;
171 	simple-audio-card,widgets = "Microphone", "Microphone Jack",
173 	simple-audio-card,routing =
184 	pinctrl-names = "default";
185 	pinctrl-0 = <&uart0_pb_pins>;
191 	pinctrl-names = "default";
192 	pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
193 	uart-has-rtscts;
197 /* On Pi-2 connector */
199 	pinctrl-names = "default";
200 	pinctrl-0 = <&uart2_pins>;
206 	pinctrl-names = "default";
207 	pinctrl-0 = <&uart3_pins>;
213 	pinctrl-names = "default";
214 	pinctrl-0 = <&uart4_pins>;