Lines Matching +full:wakeup +full:- +full:source
1 // SPDX-License-Identifier: GPL-2.0-only
3 * Copyright (C) 2013 Texas Instruments Incorporated - https://www.ti.com/
5 /dts-v1/;
7 #include <dt-bindings/input/input.h>
9 #include "omap-gpmc-smsc911x.dtsi"
13 compatible = "ti,omap3-ldp", "ti,omap3430", "ti,omap3";
22 cpu0-supply = <&vcc>;
27 compatible = "gpio-keys";
28 pinctrl-names = "default";
29 pinctrl-0 = <&gpio_key_pins>;
35 wakeup-source;
42 wakeup-source;
49 wakeup-source;
56 wakeup-source;
63 wakeup-source;
70 wakeup-source;
77 wakeup-source;
84 wakeup-source;
91 wakeup-source;
101 compatible = "ti,omap2-nand";
103 interrupt-parent = <&gpmc>;
106 linux,mtd-name = "micron,nand";
107 nand-bus-width = <16>;
108 gpmc,device-width = <2>;
109 ti,nand-ecc-opt = "bch8";
111 gpmc,sync-clk-ps = <0>;
112 gpmc,cs-on-ns = <0>;
113 gpmc,cs-rd-off-ns = <44>;
114 gpmc,cs-wr-off-ns = <44>;
115 gpmc,adv-on-ns = <6>;
116 gpmc,adv-rd-off-ns = <34>;
117 gpmc,adv-wr-off-ns = <44>;
118 gpmc,we-off-ns = <40>;
119 gpmc,oe-off-ns = <54>;
120 gpmc,access-ns = <64>;
121 gpmc,rd-cycle-ns = <82>;
122 gpmc,wr-cycle-ns = <82>;
123 gpmc,wr-access-ns = <40>;
124 gpmc,wr-data-mux-bus-ns = <0>;
126 #address-cells = <1>;
127 #size-cells = <1>;
130 label = "X-Loader";
134 label = "U-Boot";
152 interrupt-parent = <&gpio5>;
159 clock-frequency = <2600000>;
164 interrupt-parent = <&intc>;
167 compatible = "ti,twl4030-power-idle";
175 #include "omap3-panel-sharp-ls037v7dw01.dtsi"
182 clock-frequency = <400000>;
186 clock-frequency = <400000>;
191 regulator-always-on;
195 enable-gpios = <&twl_gpio 15 GPIO_ACTIVE_HIGH>; /* lcd INI */
196 reset-gpios = <&gpio2 23 GPIO_ACTIVE_HIGH>; /* gpio55, lcd RESB */
197 mode-gpios = <&gpio2 24 GPIO_ACTIVE_HIGH>; /* gpio56, lcd MO */
202 interrupt-parent = <&gpio2>;
204 pendown-gpio = <&gpio2 22 GPIO_ACTIVE_HIGH>;
210 compatible = "ti,omap3-pre-es3-hsmmc";
211 vmmc-supply = <&vmmc1>;
212 bus-width = <4>;
213 pinctrl-names = "default";
214 pinctrl-0 = <&mmc1_pins>;
226 gpio_key_pins: gpio-key-pins {
227 pinctrl-single,pins = <
240 musb_pins: musb-pins {
241 pinctrl-single,pins = <
257 mmc1_pins: mmc1-pins {
258 pinctrl-single,pins = <
290 interrupts-extended = <&intc 74 &omap3_pmx_core OMAP3_UART3_RX>;
294 pinctrl-names = "default";
295 pinctrl-0 = <&musb_pins>;
296 interface-type = <0>;
297 usb-phy = <&usb2_phy>;
304 regulator-name = "vcc";